USOUND CARME 3.0 UJ-R1030 Instruction manual

FEATURES
Speaker box with 100 mm³
back volume
Provides a convenient way to
connect and test Ganymede MEMS
speakers (Adap and Achelous)
Compatible with the development
board Helike UA-E3010
PACKAGE CONTENT
Shell and speaker gasket glued
PCB with 1 m cable to 2.54 mm
crimp tin contact
Housing gasket
Two screws
*Carme is delivered assembled.
SPEAKER BOX
CARME 3.0 UJ-R1030
QUICK USER GUIDE
Carme 3.0 is a speaker box
designed for testing the
performance of our Ganymede
MEMS speaker series.
Carme 3.0 is designed to be
compatible with our latest
development board Helike.
*The speaker is not included.

To put the Ganymede MEMS speaker inside of the speaker
box, rst, unscrew and separate the PCB from the shell.
Remove the housing gasket and place the Ganymede MEMS
speaker with the contact side up.
Place the housing gasket and the PCB on the shell, matching
the orientation marks available on the speakers and on the
PCB. For proper sealing, ensure that the screws are correctly
tightened.
Make sure that the green wire (connected to the + pad in
Carme 3.0) must be connected to the upper pin on the Helike
board as seen in the photo above.
Carme 3.0 can be connected to both headers (MEMS L or
MEMS R) as seen in the picture on the right.
The correct placement of the Ganymede MEMS speaker is
illustrated on the following page.
SETTING UP THE SYSTEM
The speaker box Carme 3.0 is an accessory of the development board Helike UA-E3010.
Should you require assistance or further information, please contact [email protected].

Shell
Speaker gasket
Housing gasket
Ganymede
MEMS Speaker
(Not included)
PCB
2x Screws
(Glued to the shell)

Carme 3.0 UJ-R1030 Quick user guide
Released on September 2020
USound GmbH | www.usound.com | [email protected]
IMPORTANT NOTICE AND DISCLAIMER
USound GmbH (“USound”) makes no warranties for the use of USound products, other than those
expressly contained in USound’s applicable General Terms of Sale, located at www.usound.com.
USound assumes no responsibility for any errors which may have crept into this document, reserves
the right to change devices or specications detailed herein at any time without notice, and does not
make any commitment to update the information contained herein. No license to patents or other
intellectual property rights of USound are granted in connection with the sale of USound products,
neither expressly nor implicitly.
In respect of the intended use of USound products by the customer, the customer is solely
responsible for observing existing patents and other intellectual property rights of third parties
and for obtaining, as the case may be, the necessary licenses. For more information about USound
patents visit https://www.usound.com/patents/.
Important note: The use of USound products as components in medical devices and/or medical
applications, including but not limited to, safety and life supporting systems, where malfunctions
of such USound products might result in damage to and/or injury or death of persons is expressly
prohibited, as USound products are neither destined nor qualied for use as components in such
medical devices and/or medical applications. The prohibited use of USound products in such medical
devices and/or medical applications is exclusively at the risk of the customer.