Uspa UB-6035R Instruction Manual

VIA MONTEVERDI, 8
28100 NOVARA-ITALY
it in

15
16
14
19
20
19
this appliance properly
repair this appliance by yourself. Doing so could void the warranty.

0.08 MPa 0.75 MPa.
during
in the
WARNING Before installing this product, always observe the
local laws and regulations regarding installation
In countries where power outlets are not permitted in bathrooms, such as U.K. or Ireland, please consult a
qualified electrician for advice on connecting this unit to a power supply. The European two pin plug should be
removed and the unit should be connected to the mains by a qualified electrician.
In such countries, every time the operating instruction manual refers to unplug the power cord, the user must
instead switch off the circuit.
CONTINENTAL EUROPE
U.K. / IRELAND
an excessive
maintenance and cleaning.

outlet
circuit

skin.
multiple adapter.

forcefully
is set up, it may result in
burn

Press “IIP” button again to change the frequency of the pulsation mode
available). Initially water pressure is set to level 5.
(3 different modes
()
(aerated spray)
:
Press “Auto” to activate Automatic function: Wash - Oscillation - Pulsation will operate
consecutively for 1 min. and Drying for 3 mins.
by pressing from 1 to 5 positions when being used.
Nozzle position can be adjusted by pressing the Nozzle Position button and then

the “Power” LED
choices
is
The ID of the body will be preserved eternally after setting up, even in case of
blackout or reactivating the device after unplugging.
If Remote Control and main unit IDs are different, bidet will not work.
Press “Power Bidet” again for 1 second at least and simultaneously press “Stop” on
the Remote Control. You will hear a buzzer sound.

Initially water pressure is set to level 5.
Press “Auto” to activate Automatic function:
Wash - Oscillation - Pulsation will operate consecutively for
1 min. and Drying for 3 mins.

14
(1/2" , 3/8")

Detach the unit.

sequence shown in the picture.
respecting the
430 480
400 450
410 460

remote control.

Plug the power cord into the outlet. Press “BIDET” or “CLEANSING”, then water tank will be filled
within 2 minutes. After the water tank has filled up, you will hear a long buzzer sound.
Cover the toilet bowl using the plastic wrapping sheet of the unit to prevent water from being sprayed
out of the toilet.
Then check for all the functions described in this manual.
(1/2" , 3/8")

Open the shutoff valve
1.8m
(W)392mm X (L)520mm X (H)143mm
(W)392mm X (L)490mm X (H)143mm
(W)466mm X (L)520mm X (H)143mm
(W)466mm X (L)4900mm X (H)143mm
(W)392mm X (L)504mm X (H)143mm (W)466mm X (L)504mm X (H)143mm
0.08MPa

(2)