UTEK UT-5510 User manual

Opto-Isolation Data I/O Controller
Model ：UT-5510
User Manual
COPYRIGHT （C）UTEK INC 1997-2006
ALL RIGHTS RESERVED

Table of Contents
Chapter 1 General Information
1.1 Product Introduction
1.2 Product Applications and Specifications
Chapter 2 Installation
2.1 Product Appearance
2.2 Connector Allocation
Chapter 3 Control Programming
1. QUICK BASE Programming Sample

Chapter 1 General Information
1.1 Product Introduction
Model UT-5510 opto-isolated parallel data input/output controller uses four 8-bit channels for
data input and another four 8-bit channels for data output. A ll data input/out is compatible with
TTL/DTL electrical level. E very data input/output channel is similar to that of computer interface.
1.2 Product Applications and Specifications
-- M ulti-signal status monitoring
-- P arallel data transmission and communication
-- I ndustrial automation and control
-- L aboratory automation and control
-- M ulti-channel signal conversion control
-- I nduction electric eye monitoring
-- P roduction line automation contro
-- Automated test guide
Chapter 2 Installation
2.1 Product appearance

22. Connector allocation
D ata devices use 10-pin terminals as their input/output interfaces. Pin allocation is as follows:
Note ：
--GND: Ground
--VCC: DC9 — 30V power input, operating current: 350mA
--DATA-: communication interface (RS232: data receiving; RS485: RS485-)
--DATA+: communication interface (RS232: data sending; RS485: RS485+)
--INIT: Reset
--IN.COM : 5-24 negative voltage common input end
--IN0 、IN1 、IN2 、IN3: 5-24V positive voltage input
--NO1 、NO2 、NO3 、NO4: relay normally open end
--NC1 、NC2: relay normally closed end
--COM1 、COM2 、COM3 、COM4: relay common end
CN1 ：
C onnection socket 1:
CN2 ：
C onnection socket 2:

Chapter 3 Control Programming
1. QUICK BASE Programming Sample
Input:
CLS
CALL OUT PORTA ，1
OUT PORTA,1+2
SLEET(1)
OUT PORTA,0
Input:
CLS
PORTA=&H2A0
A=INP(PORTA)
PRINT A
B=INP(PORTA)AND 2
PRINT B
Clear Screen
Output & H2A0 Address ’ 0 digit is with high electric level (DO0-DO7,
10000000)
Output & H2A0 Address ’ 01 digit is with high electric level
(DO0-DO7, 11000000)
Pause one second
Output & H2A0 address ’ all output data are with low electric levels
Clear Screen
Define input address.
‘ Read&H2A0 interface 8-bit data status. (DI0-DI7)
Print A ’ s value to the screen.
‘ Specific read & H2A0 second digit interface and data status. (DI1)
‘ Print B ’ s value to the screen.