V-TAC VT-820 User manual

INSTALLATION INSTRUCTION
LED BOLLARD LIGHT
WEEE Number: 80133970

INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best.
Please read these instructions carefully before starting the installing and keep this
manual handy for future reference. If you have any another query, please contact
our dealer or local vendor from whom you have purchased the product. They are
trained and ready to serve you at the best. The warranty is valid for 2 years from
the date of purchase. The warranty does not apply to damage caused by incorrect
installation or abnormal wear and tear. The company gives no warranty against
damage to any surface due to incorrect removal and installation of the product.
The products are suitable for 10-12 Hours Daily operation. Usage of product for 24
Hours a day would void the warranty. This product is warranted for manufacturing
defects only.
TECHNICAL SPECIFICATIONS
WARNING!
1. Please turn off power and read this instruction before starting the installation.
2. Install only by certified Electrician.
This marking indicates that this product
should not be disposed of with other house-
hold wastes.
Model Wa�s Lumens Beam Angle CRI PF IP Body Dimension
VT-820 10 450 72° >80 >0.5 IP65 Aluminium 108x800mm
VT-830 10 450 72° >80 >0.5 IP65 Aluminium 108x250mm
Caution, risk of electric shock.

STRUCTURE

In case of any query/issue with the product please reach out to us at [email protected]
INSTALLATION INSTRUCTIONS
1. Switch off the power before installing the lamp.
2. To drill the appropriate holes on the cement floor. (Picture 1)
3. Do the wateproof measure for the wire junction and then Connect the electricity
AC:100-240V. (Picture 2)
4. Fix the lamp on the floor by screw. (Picture 3)
5. Cover the nut cap and switch on the power if above steps are done properly
without any mistakes. (Picture 4)
Do the waterproof measures for
the wire junction.
Cover the nut cap.Fix the lamp on the floor by
screw.