Valcom V-1013B User manual

TECHNICAL ASSISTANCE
When trouble is reported, verify there are no broken connections to the unit.
Assistance in troubleshooting is available from the factory. When calling, you
should have a VOM and a lineman's test set available and be calling from the job
site. Call [phone] and press 1 for Technical Support, or visit our website at
http://www.valcom.com.
Valcom equipment is not field repairable. Valcom, Inc. maintains service facilities in
Roanoke, VA. Should repairs be necessary, attach a tag to the unit clearly stating
your company name, address, phone number, contact person, and the nature of the
problem. Send the unit to: Valcom, Inc.
Repair and Return Dept.
5614 Hollins Road
Roanoke, VA 24019-5056
WARRANTY
Warranty information may be found on our website at
www.valcom.com/warranty.
INSTALLATION INSTRUCTIONS FOR
AMPLIFIED TRACK STYLE SPEAKERS
MODEL NO. V-1013B AND V-1014B
Issue 2 947035

VALCOM ONE-WAY AMPLIFIED TRACK STYLE SPEAKERS
Valcom Track Style Speakers, V-1013B (one-watt) and V-1014B (five-watt), are
weather resistant, self-amplified and provide voice paging as well as background
music. These speakers have externally accessible volume controls that are adjustable
by a screwdriver through the hole in the grille and are available in white, black and
gray. Model V-1013B-W White Model V-1014B-W
Model V-1013B-BK Black Model V-1014B-BK
Model V-1013B-GY Gray Model V-1014B-GY
DIMENSIONS/WEIGHT
V-1013B- 5.80” Dia. x 8.80” H (14.73cm Dia. x 22.35cm H)
2.5 lbs. (1.13kg)
V-1014B- 5.80” Dia. x 8.80” H (14.73cm Dia. x 22.35cm H)
3.1 lbs. (1.41kg)
The V-1013B requires -24VDC, 50mA (1 Valcom Power Unit) and the
V-1014B requires -24VDC, 300mA (6 Power Units).
Note: DO NOT connect this speaker directly to a 25/70/100 Volt
amplifier as damage to both the amplifier and speaker may
occur.
INSTALLATION
1. Mount the bracket.
2. Remove knobs and mount speaker to bracket.
3. Attach knobs and position at the desired angle. Tighten knobs (See Figure
Typical coverage of these speakers is 600 square feet with good quality
paging heard up to thirty feet in front of the speaker. Speakers should be
spaced approximately twenty feet apart. The five-watt version is
recommended for higher noise level areas.
CONNECTIONS
Recommended Quantity of Speakers per Specific Power Run
Speakers per Power Run Wire Run Length (Feet)
V-1013B V-1014B 24AWG 22AWG
15
7
3
2
1
0
250
500
1000
400
800
1600
TROUBLESHOOTING CHART
SYMPTOMS ACTIONS
No audio from
speaker
Low volume from
speaker
Loud squeal
(feedback)
1. Verify volume control is turned up (clockwise).
2. Using a lineman's test set, check for proper audio
level at Tip and Ring leads and if necessary at the
source.
1. Verify volume control is turned up.
2. Check voltage at the speaker when in use, (-18 to
-24VDC required).
3. Using a lineman's test set, check for proper audio
level on Tip and Ring leads. It is possible that
some low, level audio will be heard with only one
side of Tip and Ring connected.
1. Decrease volume of speaker (counterclockwise).
2. Increase the distance between telephone and
speaker.
3. Install confidencer on the telephone in severe
problem areas.
Knob
Mounting
Bracket
FIGURE 1
Volume
Control
(Tip/A) Green
(Ring/B) Red
(-24VDC) White
(GND) Black
One-Way
A
mplified
Speaker
Page
Out
Valcom Pag
e
Control
Valcom -24VDC
Power Supply
FIGURE 2