Valley-Dynamo BIG D User manual

Register your table and order replacement parts at www.valley-dynamoparts.com
ASSEMBLY INSTRUCTIONS
Accessory Pack Contents
SOCCER LEG 4
LEG BOLT 16
NUT 16
WASHER 16
RED PLASTIC PLAYER 13
BLUE PLASTIC PLAYER 13
TWO MAN ROD 2
THREE MAN ROD 2
GOALIE MAN ROD (shorter than 3 man) 2
FIVE MAN ROD 2
MAPLE HANDLE 8
SOCCER BALLS 3
SCORE POST 4
#10 x 2½”OVAL HD BLK OXIDE SCREWS 4
BLONDE SCORE DISK 5
BLACK SCORE DISK 5
SCORE POST ROD 2
BUMPER 16
LEG LEVELER 4
8-32 x 1¼”SCREWS 23
8-32 NYLOC NUTS 23
RULE BOOKLET 1
SILICONE IN 2 oz. BOTTLE 1
Tools Required
SMALL HAMMER
PHILLIPS SCREWDRIVER
9/16” BOX-END OR SOCKET WRENCH
ALL-PURPOSE CLEANER (Fantastik, Formula 409, Windex or equivalent)
CLEAN CLOTH

Register your table and order replacement parts at www.valley-dynamoparts.com
1. Remove all parts and accessories from parts box and check against the enclosed list.
2. Turn the table upside down, taking care not to scratch the top or bend the Corner Cap
(assemble on carpet or cardboard).
3. Remove the nuts and washers from each leg and insert the leg into the two diagonal
holes in the bottom of the game.
4. Assemble the nuts and washers to the leg bolts and finger tighten. Make sure each leg
is pulled squarely into the comer of the cabinet on all four sides, before tightening
with a wrench. Be careful not to over-tighten the nuts. Make sure the Leg Levelers are
screwed in all the way.
5. Have two people set the table upright. Wipe it off with a damp cloth.
6. Thread the appropriate rods through the corresponding bearing hole (be careful,
there are four 3-holed rods and the two shortest of these four rods are the goalie
rods). Thread the rod through one side of the cabinet and wipe a thin coating of
silicone on the rod using a cloth or paper towel. Thread one black rubber bumper
onto the rod (make sure that the side of the bumper with the holes always faces the
cabinet wall).
7. Thread the appropriate number of men onto each rod (the nut hole is in the back of
the man), followed by another rubber bumper on the far end. Slide the end of the rod
into the bearing hole in the opposite cabinet wall.

Register your table and order replacement parts at www.valley-dynamoparts.com

Register your table and order replacement parts at www.valley-dynamoparts.com
8. To secure the men, align the holes in each man with the holes in the rod. Insert the
nut into the back of the man and tighten the screw.
9. Mount the score assemblies at each end of the table.
10. Level the table by rotating the Leg Leveler where required.
11. Lubricate the game at least once a month.
a. Wipe each rod with a clean dry cloth.
b. Pull the handle end of each rod out towards you and apply one drop of silicone
to the top of the rod, approximately one inch from the outside of the game.
c. Continuously spin the rod while pushing it in and pulling it out of the game.
d. Remove any excess silicone with a clean soft cloth.