Vayyar Walabot DIY 2 User manual

User manual
FCC ID: 2AHIS-VMAKERPROW
Contains FCC ID: 2AHIS-VMAKERPROUWB
IC: 21498-VMAKERPROW
Contains IC: 21498-VMAKERPROUWB
Models: VMPRO19CB4BAT,
VMPRO19CB4WREP
WalabotDIY2

2 Vayyar Imaging
What’s in the box
WalabotDIY2 device
Gel Pad
USB charging cable

3 Vayyar Imaging
Tutorial
Download WalabotDIY app from Google
Play (Android users) or from AppStore (iOS
users)
Follow the app guidance to learn how to
attach the phone to the Walabot, and how
to scan your wall properly
Choose desired wall type as instructed,
place Walabot DIY firmly on wall, where
the Teflon strips are against the wall,
then tap “Start Calibration” and move it
in a circular motion
Choose Images mode and start
scanning your wall. When you hit an
object, a visualization of it will appear
on your screen.
For more information, please visit
walabot.com/diy
Step 1 Step 2 Step 3

4 Vayyar Imaging
Warning
FCC Regulation
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
FCC Part 15 Clause 15.21
“Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment”
FCC Part 15.19(a) [interference compliance statement
“This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.”
ISED RSS-Gen Notice (in English and French):
“This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions: This device may not cause
interference. This device must accept any interference, including interference
that may cause undesired operation of the device.”
“L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : L’appareil ne doit pas produire de
brouillage;L’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.”
ISED Canada ICES-003 Compliance Label
“CAN ICES-3 (B)/NMB-3(B)”
Labels
FCC and IC certifications can be found inside the App. Go to Menu Regulation
Certifications