Vcomm resi-linx RL-IR305 User manual

6. Additional Plasma Friendly Targets can be added into the
linx-IR Repeater System by:
 (a)runningUTPcableinloopedcongurationfromone
RJ45 socket A on Receiver Module to another zone.
This can be repeated to link up to 7 Targets into the system,
depending on cable lengths and environmental conditions.
(b) using a linx-IR Distribution Hub (RL-IR170) to
allowforsimpledistributiontoupto7Targetsinastar
wiredconguration,dependingoncablelengthsand
environmental conditions.
by
1. Connect the Plasma Friendly Flat IR Target (included) into
Target Input B on Receiver Module (RL-IR505).
2. Connect Receiver Module to Distribution Module (RL-IR305)
using UTP cable plugged into RJ45 connectors A and G
at both ends.
3. Each Receiver Module can select the IR Emitter output port
K on the Distribution Module that it wishes to control. IR
Discrete Selection Switch C on Receiver Module can be
switchedtothe‘ON’positionforeitherDISCRETEA/B/
COMMON or any combination required (including all ON).
These switches correlate to the same IR Emitter Output
PortsKoftheDistributionModule.Factorysettingisset
to ‘COMMON’.
4. Ifrequired,connecteitherSingleorDouble IR Emitter (RL-
IR700/800)totheIREmitterPortEonReceiverModule
forcontroloflocalAVsource.
5. DiscreteIRfacilityspecicallyforusewithres-linxAV
Matrix System.PleaserefertoAVMatrixSysteminstallation
instructionsformoredetails.
INSTALLATION MANUAL
Receiver Module Connection (RL-IR505)
WARRANTY
VcommPtyLtdstatesthatthewarrantthatthecustomercanrelyonisthat
providedbythemanufacturer.Intheeventofanywarrantyclaimplease
contactusandwewillforwardittothemanufacturer.Themanufacturerwill
thendeterminetheextentoftheirliability.Thisexpresslynegates,tothe
extentpossiblebyAustralianlaw,anywarrantyrelianceonVcommPtyLtd.
ABN:99091281524
VcommPtyLtd
www.resi-linx.com
Patented
RL-IR305/RL-IR505
linx-IR Repeater System
resi-linx Discrete IR System
Discrete IR Selection
G RJ45 socket
H Target Input
I 12VDCInput
J IR/PWRLEDs
K IR Emitter ports
®
¸
Local IR Emitter Port
IR Line Out
Additional IR Zones
IR Zone 1
UTP cable
Flat IR Target
RL-IR505
Receiver Module
Remote
Control
RL-IR305
Distribution Module
Remote
Control
To additional IR
zonesifrequired
IR Zone 2
RL-IR505
B
C
E D
I
A
G
F
RL-IR305
A RJ45 sockets
B Target Input
C Discrete IR Selection switch
D IR Line Out
E Local IR Emitter port
F IR/PWRLEDs
KJ
H
®

WARRANTY
VcommPtyLtdstatesthatthewarrantthatthecustomercanrelyonisthat
providedbythemanufacturer.Intheeventofanywarrantyclaimplease
contactusandwewillforwardittothemanufacturer.Themanufacturerwill
thendeterminetheextentoftheirliability.Thisexpresslynegates,tothe
extentpossiblebyAustralianlaw,anywarrantyrelianceonVcommPtyLtd.
ABN:99091281524
VcommPtyLtd
www.resi-linx.com
7. Ifrequired,connectIRTargetgreenconnectordirectlyinto
TargetInputHforlocalIRcontrolofAVsource.
8. (a)ReferPoint3.ConnectIREmitter(RL-IR700/800)to
correspondingIREmitterOutputportseitherDISCRETEA/B
 /COMMONKoranycombinationrequired(asselectedon
ReceiverModule/s).
 (b)Placetheemitterhead10mmtoeithersideoftheIR
receiverontheAVsource(dependingonenvironmental
conditions). Single emitters (RL-IR700) or Double
Emitters(RL-IR800)canbeuseddependingoninstallation
requirements.
9. CommonIRoutputportfordirectconnection,using3.5mm
to3.5mmlead(included)to‘DirectIRInput’portonAV
device.
10.Connectthe12VDC500mApowerpack(included)tothe
12VDCinputI.CheckthegreenPWRLEDJis
illuminated.
IR LED indicators on both Receiver Module and Distribution
ModuleilluminatebrieyuponreceiptofIRcommands.
NOTE: Some brands of TV/Monitors can reduce the
range of the IR Receiver head, which is outside the
scope of the warranty.
(refertowww.resi-linx.comforfurtherinformation)
Distribution Module Connection (RL-IR305)
Discrete IR Selection
Direct IR output port
Troubleshooting
linx-IR Repeater System
Frequency Range 20-200kHz
PowerInputRL-IR305 12VDC500mA
- Switch Mode
Cable requirement UTP
Maximum cable length per system Up to 60 metres
Maximum Target reception distance Up to 10 metres
Maximum Targets per system Up to 7 targets
by
RL-IR305/RL-IR505
linx-IR Repeater System
resi-linx Discrete IR System
®
¸
Patented