VeGue VS-0866 User manual

Product features
Charging instructions
Common function description
VOLUME：Adjust volume
TREBLE：Adjust treble
BASS： Adjust bass
MIC VOL：Adjust microphone volume
ECHO：Adjust echo
MIC：Wired microphone input
This system can be used with PC, DVD, VCD, MP3, Electronic Piano, Radio and any device
with audio output.
The amplifying circuit is designed with high performance and high fidelity, and equipped with
professional and high quality speaker, it can make the sound field positioning clear and layered.
The system voice effect is outstanding, the bass is surging and shocking, the middle tone is
strong and bright, the treble is crisp and pleasant.
Professional electronic frequency division circuit, so that the division point of the machine more
accurate, better effect.
The use of professional design and manufacture of large capacity batteries, as well as audio
power supply capacitor makes the local power reserve margin more larger,more stable,better
dynamic,higher SNR.
When charging, use the power transformer that comes with the package to connect AC
100V ~ 240V voltage for charging. The charging time should be 6 ~ 8 hours. After being fully
charged, unplug the power supply to avoid damage to the battery due to long-term charging.
Battery level indicator: There is a battery level indicator on the display.
When the battery power is too low, the battery indicator icon will flash, please
charge it in time. The red light on the display will light up when charging, and
the blue light on the display will light up when fully charged.
Note: If the battery is used out, please recharge the battery within 48
hours.Do not leave the empty battery for a long time, otherwise the battery will be
damaged.
Output power-----------------------------------
Input sensitivity---------------------------------
SNR-----------------------------------------
Frequency response-----------------------
Power supply----------------------------------
160W
320mV
≥70dB
60Hz~20KHz
DC 15V
*Above specifications are the specifications of the sampling machine and are for reference purpose only.
*Because of continuous product improvement.specifications will keep changing at any time without prior
notification.
Main technical specifications
Portable BT speaker systemPortable BT speaker system
Portable BlUEBOOTH speaker
VS-6633VS-6633
VS-0866
Instruction Manual
Trouble shooting guide
Common
problems Possible Cause Solution
There is
no sound
when
power is
on
Distortion
of sound
Mic
is silent
MP3
is silent
1. No input source.
2. The main volume is at the
minimum position.
1. Use better music signals.
2. Adjust the volume appropriately.
1.Turn down the main volume.
2. Check whether the speaker is
damaged or not.
If it so, it needes to be repaired.
1.Volume is adjusted to max.
2.Speaker may be damaged.
1.USB song format is wrong.
2. Improper operation leads to
procedural chaos.
3. The USB /TF card is not
inserted properly.
1. Convert the format to MP3.
2. Restart the machine.
3. Unplug and re-plug into
the USB/TF card.
1. The microphone switch is not
on.
2. Mic volume is at 0 position.
3. Low battery of wireless
microphone.
1. Turn on the microphone switch.
2. Adjust the microphone volume
appropriately.
3. Replace the wireless microp-
hone battery.

*Image diagram, for reference only
Guitar Recording function
Play function
Bluetooth operation
USB/TF
Microphone controls and basic operation
GUITAR: Connect guitar.
GUITAR VOL: Adjust the guitar volume.
Music files in USB and TF cards should be formatted as FAT32 on the computer.
The order about music play is based on file name,if the music file names are as "01,02,03"in
sequence.This product will play the file "01"first.
Copy MP3 or WMA music files to USB/TF cards. It is recommended to delete unnecessary
files and folders to speed up card reading and reduce card reading problems
*Image diagram, for reference only*Image diagram, for reference only
*Image diagram, for reference only
1.Under normal circumstances, the remote control
should be used within a range of about 20 feet and
30 degrees from the remote reception window.
2.When operating the remote control, point the
remote control at the receiver window of the
machine. There should be no obstacles between
the remote control and the machine.
3.If the receiving window is in the position of strong
light, the remote control may fail. In this case,
please remove the machine to avoid direct
exposure to strong light.
4.Please don't make both new and old batteries
work together,and regularly check whether the
remote control batteries need to be replaced.
Remote control instructions Description of controls
USB: insert USB and play music.
TF: insert TF card and play music.
Supports MP3, WMA, and WAV music formats, outstanding sound performance, high fax
stereo design.
INPUT: to switch external audio, MP3 / Bluetooth/ Radio functions.
►||: press this key to pause the music, and press again to continue.
|◄◄ / ►►|: when playing, select the PREVIOUS/NEXT music.
20 feet
for 3 seconds to adjust frequency.
1. Mute
2. Music number
3. Input mode
4. Volume +
5. Play/Pause
6. Next
7. Volume -
8. USB
9. EQ
10. Playback
11. Record
12. Bluetooth
13. Previous
14. Microphone priority
15. Repeat
1. DC 15V IN
2. MIC Jack
3. MIC Volume
4. Echo
5. Volume
6. Bass
7. Treble
8. Guitar Volume
9. Guitar Jack
10. Audio Output
11. Audio Input
12. TF Slot
13. USB Slot
14. Power switch
15. Input selection
16. Previous
17. Play / Pause / Scan
18. Next
19. Repeat
20. LED Light Control
21. Record / Playback
22. MIC Priority
Please insert USB or TF card first and then press “●/►” into recording mode. When
recording music at the first time, an new file "VOICE" will be created in the card and all recordings will
be saved into the file. These recording files are automatically named as REC001,REC002,REC003…
in sequence. When recording music, press “●/►” to puase it and press again to continue. Press
INPUT or “●/►” to quit recording mode.
Please press “●/►” into recording-play mode(automatically play the musics recording
before). Usually the machine will play the last recording music first. Press PREV( |◄◄) or NEXT
( ►►|) to select the music. Press Replay on the remote control to replay music. If you would like
to replay single music or all musics, please press Replay repeatedly.
Bluetooth connection method:Turn on the speaker,press the‘INPUT’key on the speaker
panel,and the screen will show‘bLUE’.Use your phone to connect the Bluetooth of the
speaker. The Bluetooth name is VS-0866.
If the connection fails,please restart the device or the phone and try again.
The use range of the Bluetooth is 32ft in the open area.
How to pair with mic?
1. Press C to turn on Mic first. Then, hold down the button D or E for 2-3 seconds into
Set mode.
2. When SET is flashing on the screen, press D or E to select frequency. There are 3
requencies. If one of them doesn't work, please change to different one.
3. After selecting the desired frequency, aim the "signal transmitting area (A)" at
the" circular infrared receiving area "on the machine.
4. Wait 4-5 seconds for the microphone pairing to complete. Then test whether
the microphone has been successfully connected to the machine. If the
connection is unsuccessful, please follow the above steps to reset. Or contact us
directly and we will send the replamcent mic to you.
FM function
Press“INPUT” to switch to FM radio.
Press “ ►||” for automatic searching and saving.
Press“ |◄◄“and “ ►►|” to switch channels.
Note: Both Mics have already completed the pair at the factory.
There is no need for any adjustment. But if it doesn't work,
please try below methods.