Velbon Super Mag Slider User manual

Super Mag Slider
Thank you very much for purchasing
Velbon Super Mag Slider. Please read
these instructions carefully and complete-
ly to insure proper handling before use. The name of each part
OCamera screw
Osleeve nut
@Camera
platform
@Focusing (Forward-
Backward) knob
Attached tools 6
)a
t>/
Hex. wrench 1
SMS Supanner 1
Back side ol platform
@Traversing
(Left-Center-
Right ) knob

Attaching the Super Mag Slider to the tripod
AB
Use either A or B camera screw mounts when
attaching the Super Mag Slider to the tripod. Choose
the mount which offers better balance, this will
depend onthe position of the tripod screw.
Both A and B camera screw mounts are fitted Adapter can be
wilh 114"x20 adapters. If the tripod screw is 3/8" illustration.
x16 thread simply remove the adapters.
removed
Mounting your Camera to the Super Mag Slider
Camera mountiog knob@
Guide shaft@
Align the camera screw O to the camera screw
mount and tighten the Camera mounting knob
@. The lens should face foruard to the Guide
shaft @ when mounting the camera.
Detaching and attaching top and bottom
The Focusing slider @ can be used separately if left
@. To detach, turn the Traversing knob @ to the
illustration and turn to the left to detach.
To reattach simply reversethis procedure.
Operating forward and backward
Forward and backward
@Focusing (Forward-
Backward) knob
The Focusing knob @ adjusts forward and
backward movement. The spiral gear is designed
to lock in place when the Focusing knob is
released. The Focusing knob moves in 4mm or
0.16" increments allowing for precise camera
positioning.
Operating left and right
Left and Right
@Traversing (Left-Center-Right) knob
The Traversing knob @ adjusts left and right
operation. The screw gear is designed to lock in
place when the Traversing knob is released. The
Traversing knob moves in 4mm or 0.16"
increments allowing for precise camera
positioning.
lnstallment hole for traversing slider
and right adjustmentsare not needed.Use the enclosedHex_wrench toremovethe Traversing slider
right to exp6se Hex nut on the botttom of the Slide plate O lnsert Hex wrench as shown- in the
\\ '^,l \
\fi \
]F\ 1/4" 2o Adapter
/t
Velbon
VELBON CORPORATION
Velbon Bldg. 1-5, Nogata 6-Chome
Nakano-Ku Tokyo 165-0027 Japan
http://www.vel bon.com
This document was archived February 2014 for
photomacrography documentation purposes at the
http://extreme-macro.co.uk extreme macro website.
All rights reserved by the document authors.