Vent-Axia Slimpak EC Series Assembly instructions

EC Slimpak Fan
Single In-line Duct Fan Range
(SLP EC)
Installation and Wiring Instructions
SLP100EC
SLP125EC
SLP150EC
SLP200EC
SLP250EC
SLP315EC
SLP400EC
SLP500EC
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
THESE INSTRUCTIONS SHOULD BE LEFT WITH THE END USER

IMPORTANT SAFETY INFORMATION
1. DO NOT install this product in areas where the following may be present or occur:
2. Excessive oil or a grease laden atmosphere.
3. Corrosiveorammablegases,liquidsorvapours.
4. Subject to direct water spray from hoses.
5. Ambient temperatures higher than 40°C or less than –20°C.
6. Possible obstructions which would hinder the access or removal of the Fan.
7. AllwiringmustbeinaccordancewiththecurrentIEEwiringregulationsBS7671,or
appropriate standards of your country. Installation should be inspected and tested by a
suitablyqualifiedpersonaftercompletion.
8. Ensurethemainssupply(voltage,frequencyandphase)complieswiththeratinglabel.
9. A means for electrical disconnection must be incorporated in the fixed wiring to the unit
in accordance with the wiring rules having a contact separation in all poles of at least
3mm.
10. These units must be earthed.
11. Precautions must be taken to avoid the back-flow of gases into the building from the
open flue of gas or other fuel-burning appliances.
12. Thisapplianceisnotintendedforusebypersons(includingchildren)withreduced
physical,sensoryormentalcapabilities,orlackofexperienceandknowledge,unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
13. Young children should be supervised to ensure that they do not play with the
appliance.
14. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out,thisappliancemustnotbesuppliedthroughanexternalswitchingdevice,suchas
atimer,orconnectedtoacircuitthatisregularlyswitchedonandoffbytheutility.
15. These units are rated IP22 and are not suitable for outside use.
INSTALLATION GUIDANCE:
1. The installer is responsible for the installation and electrical connection of the system on site. It is the responsibility
oftheinstallertoensurethattheequipmentissafelyandsecurelyinstalledandleftonlywhenmechanicallyand
electrically safe.
2. Shortductrunsterminatingclosetothefan(i.e.within1.5m)requiresuitableguards.
3. Allregulationsandrequirementsmustbestrictlyfollowedtopreventhazardstolifeandproperty,bothduringand
afterinstallation,andduringanysubsequentservicingandmaintenance.
4. Certainapplicationsmayrequiretheinstallationofsoundattenuationtoachievethesoundlevelsrequired.
5. SLPECunitsaredesignedandspeciedforusewithVent-Axiacontrols,dampers,grillesandaccessories.
6. Allmainsconnectionstotheunitusingexiblewiringoranyadditionalcontrolswiringmustusecableglands
sufcienttoretaintheIPratingoftheunitandprovidecableretentiontotherequirementsofEN60335-1
Clause 25.15.
7. Thexingsandanchorsusedtosuspendandmounttheunitmustbecompatiblewiththeunit’sweight.
Suitable drop rods and anti-vibration mounts can be used.
8. Due to the weight of the units it is recommended that two people are involved in the installation.
9. Itisrecommendedthatexibleconnectionsareusedbetweentheunitandrigidducting.
IMPORTANT: READ THESE INSTRUCTIONS
BEFORE COMMENCING THE INSTALLATION

1a
1b Foroororceilingmounting
SLP100EC
SLP125EC
SLP150EC
SLP200EC
SLP250EC
SLP315EC
SLP400EC
SLP500EC
Foroororceilingmounting
Fixing locations Fixing locations
Fixing locations
Fixing locations

2Cable entry locations
mains wiring cable entry
control wiring cable entry
SLP100EC
SLP125EC
SLP150EC
SLP200EC
SLP250EC
control wiring cable entry
mains wiring cable entry
SLP315EC
SLP400EC
SLP500EC

3Single fan units with internal mains connection access
L1 L2 L3X L N
single phase terminals single fan
SLP100EC
SLP125EC
SLP150EC
SLP200EC
SLP250EC
L1 L2 L3
Single phase terminals single fan
SLP315EC
SLP400EC
L1 L2 L3
Three phase terminals single fan
SLP500EC
Control panel wiring for external speed control
10V 0V0-10V
MIN
SPEED
MAX
EX
INT
Internal speed
control ONLY
Move switch to
EX position
10V
0-10V
GND
L1 L2 L3X L N
Single fan units with external mains connection access
Note:
X is not used
Note:
X is not used
4
ALL
UNITS

Component Applicable Models Part Number
Motorised Impeller SLPEC100,125,150 434597
Motorised Impeller SLP200EC 434598
Motorised Impeller SLP250EC 434599
Motorised Impeller SLP315EC 434600
Motorised Impeller SLP400EC 434601
Motorised Impeller SLP500EC 434602
Control PCB SLP EC 475753
7SLPEC FAN SPARES LIST
e
d
c
b
Ø11
DIMENSIONS (mm)
MODEL abcdefgh i WEIGHT kg
SLP100EC 100 380 275 456 310 192 155 108 96 7.5
SLP125EC 125 380 275 456 310 192 155 108 96 7.5
SLP150EC 150 380 275 456 310 192 155 108 96 7.5
SLP200EC 200 435 330 511 364 287 182 122 143 12
SLP250EC 250 435 330 511 364 287 182 122 143 13
SLP315EC 315 710 540 785 572 460 286 243 230 33
SLP400EC 400 710 540 785 572 460 286 243 230 36
SLP500EC 500 898 735 975 770 577 385 326 286 58
i
g
a
h
i
f
AIR FLOW
MAINS CABLE ENTRY
6
5SLP EC IN-LINE DUCT FAN RANGE
COMPATIBLE CONTROLS
10520602 Remote Speed Control ✓
475775 Trickle/ Boost Controller ✓

HeadOfce:FlemingWay,Crawley,WestSussex,RH109YX.
UK NATIONAL CALL CENTRE,NewtonRoad,Crawley,WestSussex,RH109JA
SALES ENQUIRIES: Tel: [phone] Fax: [phone]
TECHNICAL SUPPORT: Tel: [phone] Fax: [phone]
Fordetailsofthewarrantyandreturnsprocedurepleaserefertowww.vent-axia.comorwritetoVent-AxiaLtd,FlemingWay,Crawley,RH109YX
475381B 06/17