Vents EH-17 User manual

EH-17
Outer ventilation hood
INSTALLATION INSTRUCTION

2
EH-17
www.ventilation-system.com
OVERALL DIMENSIONS
OUTER VENTILATION HOOD MOUNTING
1. Insert the air duct from indoor to protrude from outside on the
outer wall surface. Cut the air duct excess and a stream spreader
with a hack saw or with any other suitable tool.
WARNING! If the mounting place is located at high altitude,
please refer to a mounting.
(1/8’’)
min 3 mmmin 3 mm
The outer ventilation hood is designed to prevent ingress of water and foreign objects into the ventilation equipment from outside.
PURPOSE
THE UNIT SHOULD NOT BE OPERATED BY CHILDREN OR PERSONS WITH REDUCED
PHYSICAL, MENTAL, OR SENSORY CAPACITIES, OR THOSE WITHOUT
THE APPROPRIATE TRAINING.
THE UNIT MUST BE INSTALLED AND CONNECTED ONLY BY PROPERLY QUALIFIED
PERSONNEL AFTER THE APPROPRIATE BRIEFING.
THE CHOICE OF UNIT INSTALLATION LOCATION MUST PREVENT UNAUTHORIZED
ACCESS BY UNATTENDED CHILDREN.
øD
øD1
A B A1
H1
H
Model Dimensions [mm]
Ø D Ø D1 AA1 B H H1
EH-17 106 (4 3/16") 164 (6 7/16") 212 (8 3/8") 160 (6 5/16") 60 (2 3/8") 260 (10 1/4") 160 (6 5/16")

3
www.ventilation-system.com
2. Mark the fastening holes for the outer ventilation hood and drill
4 holes, 50 mm (1 /”) deep to suit the expansion anchors (6x40).
Use the back wall of the ventilation hood to facilitate the marking.
ø6 (1/4")
4 holes
155
(6 1/8")
155
(6 1/8")
3. Insert the supplied expansion anchors 6x40 into the holes.
Remove the outer ventilation hood to enable access to the
fastening holes. Pull the front part below toward you.
4. To install an air duct with a diameter of 160 mm (6 /”), remove
the adapter on the back wall.
5. Fix the rear part and the rainwater inlet of the ventilation hood to
the wall using the supplied 4 x 40 screws.
6. Cover the ventilation hood with the front part.

V113-9EN-02