4•• Installation X523 Rev 998 V20A Pole Mounting Adapter
each 5/16-18 screws, nuts, lock washers and flat washers. The accessory kit is provided with three strain relief
plugs, two liquid tight fittings, and a compression fitting.
Table 1
Mounting Components
Item No. Component Quantity Function
1Pole adapter plate 1Secures wall mount
to pole
2Pole mount bracket 2Secures pole adapter
plate to pole
318-inch chain 2Secures pole adapter
assembly to pole
424-inch chain 2Secures pole adapter
assembly to pole
5Hex-head bolt
(5/16-18 x 2-1/2) 2Secures pole
adapter/chain
assembly to pole
6Tension nut 2Secures item 5
7Tension bracket 2Secures item 5
85/16-18 x 1 screw 8 (6 used) Secures item 2 to 1
95/16-18 nut 8 (6 used) Secures item 8
10 5/16 lock washer 8 (6 used) Secures item 8
11 Flat washer 8 (6 used) Secures item 8
12 Strain relief plugs 3Plugs unused cable
entries
13 Liquid-tight fitting
(large) 1Seals cable access
14 Liquid-tight fitting
(small) 2Seals cable access
15 Chain link 2Allows lengthening of
chain
Bracket-to-Plate Installation
1. Assemble the two (2) adapter brackets to each side of the pole adapter plate using the screws, nuts, lock
washers and flat washers provided (3 on each side). Refer to Figure 1 and Table 1.
Note: Specific installation circumstances may dictate whether the required wall mount should be installed before
or after the pole adapter is in place on the pole.
2. If it is appropriate at this time, mount the selected wall mount to the pole adapter plate. Refer to the
instruction manual for the particular wall mount for installation instructions.
