Vicoustic Super Bass 90 User manual

EN
Super Bass 90
Installation Manual

EN
MATERIAL NEEDED
Included
Super Bass 90 x4
Measuring Tape
Level Flexi Glue Ultra
Not Included

EN
!
12
Wall and ceilling surfaces should be examined prior to installation, ensuring they are clean, smooth, and dry. If you have
unpainted gypsum board surfaces, these should be primed with a drywall primer (or another material manufactured
especially for the purpose), to equalize the absorption between the gypsum board face paper, joint compound, and skin
coating materials. You should then apply the paint, and allow air circulation in order to dry the paint within the time
frame specied by the paint manufacturer. Please ensure the paint is dry before installing the acoustic panel. Make sure
the room has all the necessary conditions to receive the acoustic panels. After you apply the glue on the back of each
acoustic panel, please ensure you hold the acoustic panel against the wall the required time (mentioned above), and
ensure it stays xed in place. This method is also applicable to ceiling installations.
Apply Flexi Glue Ultra on the back
of the acoustic panel, near
the edges. Do not wait longer than
10 minutes after applying the glue
to attach the panel to the wall.
Place the panel on the suitably
chose position on the wall. Once
in the desired place, press rmly
against the wall for 15 seconds.
To ensure that you maximise the strength of the glue, don’t make any adjustments
to the panel after bonding

© Vicoustic, 2019 | V1
No parts of this document might be copied and/or published without written consent of Vicoustic.
Main Oce, R&D & Logistics
Avenida do Pólo 3, Nº 159, Carvalhosa
4590-137 Paços de Ferreira, Portugal
T ([phone]
Oce
Rua Quinta do Bom Retiro Nº 16, Armazém 9
2820-690 Charneca da Caparica, Portugal
T ([phone]
Info and Sales
[e-mail]
www.vicoustic.com