Vicoustic VicAudiophile VMT Kit User manual

1
EN
VicAudiophile VMT Kit
Installation Manual

EN
2

EN
3
Not Included
MATERIAL NEEDED
Included
Wall Plugs and Screws
VicFix Corner 2+2
Flat Panel VMT x4 VicPET Wool x8
DrillLevel Measuring Tape 6mm Phillips Screwdriver
VicSpacer x4
VicFix J Prole 80mm | 3.14" x4
Multifuser 64 x2
VicPattern Ultra x4 VicFix J Prole 595mm | 23.4" x6
G1_Velcro Hook G2_Velcro Loop

EN
4
VicSpacer Installation
Mark the drill holes of the VicSpacers according to the diagram.
In the case of installing two or more units, pay attention to the spacing between
units. The dimensions marked between VicSpacers are for use of only one metal joint
between them.
575 mm
800 mm
22 mm
1
2
Wall Installation

EN
5
3

EN
6
2
Mark the drill holes of the VicSpacers according to the diagram.
In the case of installing two or more units, pay attention to the spacing between
units. The dimensions marked between VicSpacers are for use of only one metal joint
between them.
Ceilling Installation
1
575 mm
800 mm
22 mm

EN
7
3
4Cut the velcro tape G1 with the lenght of the plywood strips and apply it on the
side indicated in the diagram . In case of xing the VicSpacer with screws, we
recommend that the velcro be applied after the panel is installed.
G1
Steps Material

EN
8
4
5Apply the FlatPanel VMT. (Wall and Ceilling)
If you need a stronger attachment of the Flat Panel VMT to the VicSpacer, use
the Velcro G2 (hook) supplied with the product. Apply Velcro G2 over the Velcro
G1 already axed to the VicSpacer, remove the adhesive protector and press the
Flat Panel VMT to ensure an even and precise adherence.
Flat Panel VMT Installation

EN
9
406 mm | 15.984"
2
1
VicFix Corner Installation

EN
10
1
VicPattern and Multifuser Wood MKII 64 Wall Installation
Dene where you want to install the panels and start marking the drill holes for
xing the proles to the wall.
257,5 mm
80 mm
2
1
3