Victory Innovations VP90 User manual

VP90 • User Manual • 1
victoryinnovations.com
[phone]
VP90 Cart Accessory
User Manual

VP90 • User Manual • 2
victoryinnovations.com
[phone]
The VP90 Cart was designed as an accessory to the Victory Innovations®
backpack electrostatic sprayer. The cart allows use of the backpack at full
capacity without having to physically carry it, which is especially helpful for
extended spraying. With a wheeled cart to support the weight of the
backpack and its liquid contents, the user is less physically taxed and can
still move around freely due to the sprayer’s cordless design.
• Pages 3-7: Assembly Instructions
• Pages 8-9: How to Use
• Page 10: Frequently Asked Questions
• Page 11: Troubleshooting
• Page 12: Warranty Information
CONTENTS

VP90 • User Manual • 3
victoryinnovations.com
[phone]
ASSEMBLY INSTRUCTIONS
ITEM LETTER IMAGE NUMBER OF PIECES
A x1
B x2
C x2
D x1
E x2
F x4
G x4
H x8
I X8

VP90 • User Manual • 4
victoryinnovations.com
[phone]
A
B
E

VP90 • User Manual • 5
victoryinnovations.com
[phone]
C
F
H
I

VP90 • User Manual • 6
victoryinnovations.com
[phone]
D
H
G
I

VP90 • User Manual • 7
victoryinnovations.com
[phone]

VP90 • User Manual • 8
victoryinnovations.com
[phone]
HOW TO USE
PREPARING THE BACKPACK AND CART FOR USE
1. Using the 8’/2.4m hose provided, place the hose in the channel located on the
base of the cart, allowing around 6 inches (15 cm) of hose on the right side of the
cart. This is where the hose will connect to the backpack.
2. Place the backpack onto the cart. Tuck the waist straps behind and into the
space located behind the backpack, between the extension arms.
3. To secure the backpack onto the cart, loop the thin black strap located on top of
the shoulder straps through each black plastic clip located on each side of the
extensions.
4. Connect the hose to the backpack, starting with the electrical connection and
then the solution.
5. Insert the battery, making sure the door is closed and secure before adding any
solution to the tank.
6. Fill with chemical needed for the spraying job. It is recommended to remove the
 tankfromthebackpacktopreventanyspillageontothebackpack,cartoroor.
7. Attach the spray handle to the hose, starting with electrical connection and
ending with solution.
8. Install the nozzle and extension wand (if using) using the nozzle wrench.
1. Push or pull the backpack to the
location you intend to spray.
2. Turn the backpack on.
3. Press the trigger on the spray handle,
making sure to contact the grounding
strip on the trigger to reduce any
electrostatic discharge.
USING THE VP90 CART
Place accessories as shown in the back
handle for storage.

VP90 • User Manual • 9
victoryinnovations.com
[phone]
1. Bring the cart back to the utility closet or secure storage location.
2. Remove the tank and pour out any remaining chemical. Follow manufacturer
recommendations for storage requirements.
3. Fill the tank with approximately 50oz (1500ml) of clean tap water.
4. Place the tank with clean tap water back onto the backpack.
5. Spray clean water through the unit to clear out any remaining chemical in the
system. If using the 3-in-1 nozzle, make sure each nozzle setting is sprayed for a
minimum of 30 seconds. Spray until the tank and hose are empty.
6. Pour out any remaining water from the tank and place back on the backpack.
The cap can be left off to allow the tank to air dry.
7. Remove the extension wand and place into the extension wand holder on the cart
handle.
8. Disconnect the solution hose and then the electrical connection from the spray
handle. Allow the hose to rest over the cart handle on the hose channel.
9. Place the spray handle in the spray handle holder on the cart handle.
10. Remove the battery and place on the charger.
11. The backpack can remain on the cart for storage. Ensure the cart is stored in a
 securelocationawayfromheavyfoottrac.
Torellwithmoresolution,itisrecommendedtoturnthe
backpackoff,removethetankandllatautilitysinkto
reduceriskofspillsontothebackpack,cartoroor.
When not in use, store the spray handle in the handle on
the cart.
CLEANING OUT AND STORAGE
!

VP90 • User Manual • 10
victoryinnovations.com
[phone]
FREQUENTLY ASKED QUESTIONS
QWhere should the nozzle be
stored when the VP300
backpack and VP90 cart are
not in use?
The nozzle can be stored in
the sprayer or extension wand.
Be sure to rinse the nozzle
thoroughly before storing.
QCan I pull the cart behind me
or do I need to push it?
The VP90 cart is designed to
be either pulled or pushed,
depending on operator
preference and the space
being sprayed.
QCan the VP300 backpack be
removed after it has been
placed on the cart?
The backpack is not
permanently attached to the
cart and can be removed
whenever required. The cart
requires the use of the
included 8 foot hose. For
frequent removal, keep the
4 foot hose with the cart for
easy conversion.
QDo I need to remove the
backpack from the cart when
I’m done using it?
No, the backpack can remain
on the cart. Follow the clean
out procedures for your
backpack sprayer; these can
be done while the backpack is
secured on the cart.
QI spilled chemical on the cart.
Will this damage it?
The cart is made from durable
rotomolded plastic and can
withstand water-based
chemicals. Wipe the cart to
clean it and ensure chemical
doesn’tdripontotheoor.
QShould I clean the cart?
If there is dirt or debris on the
surface of the cart, use plain
tap water or a mild detergent
to rinse off the plastic.