Vigilate VIGRC User manual
User Manual
VIGRC Remote Controller
Battery Replacement Instructions
①Insert the flat blade of a small screw-driver into the pry-o
slot of remote controller, pry up to open the back cover.
②Replace with 1x CR2032 battery.
CR2032
3V
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
①This device may not cause harmful interference.
②This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
Pairing with Main Panel
Appearance
Features
The remote controller is an accessory of the VIGILATE smart alarm system. It helps you quickly Arm/Disarm/Home Arm/
trigger SOS in the system.
It’s small and stylish,convenient for carrying on a keychain or in your pocket/bag.
Customised shortcut button, to self define your own personal command.
Parameters
• Working Voltage DC 3V
• Battery 1 × CR2032 button battery (3V)
• Working Current ≤35mA
• Standby Current ≤10µA
• Transmission Distance Up to 180m without obstacle
•Transmission Frequency 433.92MHz
• Working Temperature
• Humidity ≤90%rh (non-condensing)
• Weight
• Dimension 74.4x34.5x16.1mm LxWxH(±0.1mm)
①Scanning the QR Code for Pairing.
②The pairing result can be confirmed on App.
Hint: How to trigger
Press and hold any button of the remote controller for about 0.5s.
15.7g(battery not included) 22g(battery included)
LED Indicator
Arm
Home Arm
Customised Shortcut Button
Disarm
SOS
Keyhole
• Home Arm
Press , the LED indicator lights on, the system enters home armed status.
Operating Clarification
• Arm
Press , the LED indicator lights on, the system enters armed status.
• SOS
Press , the LED indicator lights on, the system immediately enters emergency alarming status.
• Disarm
Press , the LED indicator lights on, the system enters disarmed status.
•Shortcut Button
-10℃~50℃
LED Indication
LED flashes once: Button is pressed and transmitter sends signal to the main panel.
The LED indicator will light up once every 15 seconds in case of low battery. Please replace the battery in time.
Push notification will be sent to your APP.
Customise this shortcut button in the App, the system will execute your self-defined command immediately.
