Viking FDB451 Series User manual

Dishwasher Door Panel
Installation
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
[phone]
For product information, call 1-888-VIKING1 (845-4641)
or visit the Viking Website at vikingrange.com
F21019A EN (101912)

3
Door Panel Installation (Purchased Separately)
For FDW100 / FDW100WS Models
2
Installation
C
Plastic
Retainers
Dishwasher Door
D
C
D
1
Plastic
Retainers
2
3
x2
D
D
D
C
C
Phillips Head
Screwdriver
#8 1-1/2” long, Stainless Steel
Flat PHD Screw
(4 su
pp
lied)
Remove plastic retainers from door panel
and discard.
Remove plastic mounting brackets from the
dishwasher and discard.
Carefully open the dishwasher door.
Remove the (2) white caps from holes (C)
and the (2) top screws from holes (D) on
dishwasher door
4
x4
D
D
C
C
Carefully secure the door panel to the
dishwasher through holes (C) and (D) using
the four flat PHD screws provided. Carefully
tighten all four screws and check to ensure
that the panel is square with the dishwasher
door.
Do not over tighten screws.
This
may cause damage to the inner door.
The unit comes with everything needed to make installing the door panel easy.
What you will need:
Note: Verify the operation of the door
counterbalance springs after installation of the
door skin.
Note: Verify that the door does not hit the
kickplate. Adjust kickplate if necessary.

5
Door Panel Installation (Purchased Separately)
For FDB451Model
4
Installation
C
Plastic
Retainers
D3 Door Skin
Dishwasher Door
D
D
C
D
D
1
C
Plastic
Retainers
2
x4
D
D
D
Torx Driver
(T-15)
#8 1-3/4” long, Stainless Steel
Truss Head Screw
(4 su
pp
lied)
WARNING
The door skin must not obstruct the
fan exhaust vent.
Position door skin on front of dishwasher
door. Snap the plastic retainers on the door
skin into the holes (C) on dishwasher door.
While holding the door skin in position,
carefully open the dishwasher door. Using
the four truss head screws provided, secure
the door skin to the four holes (D) on the
dishwasher door.
3
x4
D
D
Carefully tighten all four screws and check
to ensure that the panel is square with the
dishwasher door. Note: Verify the operation
of the door counterbalance springs after
installation of the door skin.
The unit comes with everything needed to make installing the door panel easy.
What you will need:

76