Viking D30FTW User manual

F20702A EN
®
(010810J)
V k ng Range Corporat on
111 Front Street
Greenwood, M ss ss pp 38930 USA
[phone]
For product nformat on,
call 1-888-VIKING1 (845-4641)
or v s t the V k ng Web s te at
v k ngrange.com
Viking Installation Guide
D30FTW - Designer Warming Drawer
Accessory Flush Mount Kit
For Use with DEWD10

2 3
Remov ng Ex st ng Tr m
Remove the two ex st ng s de tr m p eces from the warm ng drawer. There should be one tr m
p ece on each s de of the drawer.
Install ng Flush Mount Tr m
After remov ng the ex st ng s de tr m p eces, nstall the flush mount tr m p ece to the warm ng
drawer.
1. Remove the protect ve plast c from the flush mount tr m p ece.
2. Install the flush mount tr m p ece to the un t w th screws prov ded.
3. After nstall ng the flush mount tr m p ece, the warm ng drawer can be nstalled nto the
prepared cutout.

4 5
Secur ng Ins de the Cutout
Side View
Screw
A
Vertical Blocking
B
Bottom Spacer Blocking
CRITICAL
DIMENSIONS
A 1/2” (1.3 cm)
B 1-3/8” (3.5 cm)
Prepar ng the Cutout
In order for the un t to s t properly ns de the cutout, the bottom must be bu lt-up or “sh mmed”
by 1/2” block ng (See llustrat ons below). Th s w ll prov de stab l ty for the un t and allow t to s t
upr ght when pushed back nto the wall.
Finished Surfaces
Vertical Blocking
Bottom Spacer Blocking
LEGEND
Blocking
Finished
Surfaces
B
A
C
FLUSH CUTOUT
A 29-5/8” (75.2 cm)
B 25-1/8” (63.8 cm)
C 10-1/8” (25.7 cm)

67
Secur ng Ins de the Cutout (cont.)
Vertical
Blocking
Distance will
vary depending
on the cabinet
A
B
Top View
ScrewScrew
CRITICAL
DIMENSIONS
A 28-1/2” (72.4 cm)
B 1-1/2” (3.8 cm)