Vingtor Stentofon EAM-200 User manual

Replacing Amplifier Module on ENA2200
Item Number
Item Name
Description
102 3922 200
EAM-200
Exigo 2x200 Watt Amplifier Module for ENA2200
1 Accessing the Old Amplifier Module
Before you start the procedure:
1. Switch off and disconnect the amplifier from the power mains
2. Remove the top cover by unscrewing the 8 Torx screws using a T10 bit
When the top cover is removed, you will see the Amplifier
Module located at the side of the amplifier cabinet.

2 Demounting the Old Amplifier Module
The Amplifier Module is plugged into the Euroconnector at the bottom of the cabinet and secured with four
M4 screws as shown:
To demount the Amplifier Module:
1. Use a PZ2 bit to unfasten and remove the four M4 screws
2. Pull the Amplifier Module up to unplug it from the Euroconnector at the bottom of the cabinet
3. Lift the Amplifier Module out of the cabinet
3 Installing the New Amplifier Module
1. Align the Amplifier Module with the four screw holes
2. Press the Amplifier Module down to plug it into the Euroconnector at the bottom of the cabinet
3. Use a PZ2 bit to fasten the four M4 screws and secure the Amplifier Module to the cabinet
4. Put the top cover back in place and fasten with the 8 Torx screws
After the new Amplifier Module has been powered up and you happen to
remove it, DISCHARGE the large capacitors BEFORE inserting it back in.
WARNING
A100K11600
DOC NO.
[email protected]