VISIONARY DESIGNS MOD-1336 Manual

© 2018
Order #XXXXX
Completed Assembly
Base
Plate
Post
Wing
Wing
Plate
Clamshell
Hex
Nuts
Steps:
1) Attach base plate to straight end of post, using bolt.
2) Attach plate to curved end of post, using bolt.
NOTE: Plate must rotate to left and right before installing clamshell.
3) Attach clamshell to plate, using hex nuts. See Clamshell Attachment detail.
4) Insert iPad in clamshell, then feed cords through holes. See
Cord Management for iPad detail.
Clamshell Attachment
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
Cord from iPad
USB Extension Cord
Cord Management For iPad
Attach iPad cord to supplied USB extension
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
Cord
Access
iPad
Lock Lock
Clamshell
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can’t be
easily removed.
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
MOD-1336 iPad Kiosk

© 2018
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information