VISIONARY DESIGNS MOD-1357 Manual

© 2018
Order #XXXXX
Infill
*
*
Stand
Steps:
1) Slide Infill between verticals of stand.
2) Attach horizontal extrusion between stand verticals.
3) Attach base plate to bottom of stand verticals, using bolts.
4) Attach plate to top end of stand, using bolt.
NOTE: Plate must rotate left and right, before installing clamshell.
5) Attach clamshell to plate, using hex nuts.
6) Insert iPad in clamshell and feed cord through holes.
See Cord Management For iPad detail.
7) Attach literature holders to stand where desired.
See Literature Holder detail.
Attach connector to
literature holder. Connect
literature holder to
vertical extrusion.
Literature Holder
*
Tighten Lock
to Secure
Connector
Vertical Extrusion
Completed Assembly
Side View
Top View
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
Horizontal
Extrusion
Clamshell
Literature
Holders
Base
Plate
Plate
Hex
Nuts
Cord from iPad
USB
Extension
Cord
Cord Management For iPad
Attach iPad cord to supplied USB extension
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
Cord
Access
iPad
Lock Lock
Clamshell
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can’t be
easily removed.
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
MOD-1357 iPad Kiosk

© 2018
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information

© 2018
Case 1 of 1
Order #XXXXX
Setup Hardware with
(2) Literature Holders
Base Plate
Level 1 Level 2
Top View of Each Level
Assembled iPad Stand
iPad
Clamshell
Plate
Case Packing