visionLINE TAURUS-AU Installation instructions

2
AS/NZS 2918:2018
AS/NZS 2918:2018
AS/NZS 2918:2018

AS/NZ 2918:2018.
6mm
- 42mm thick hearth when the unit is installed at the minimum
100mm from floor level (100mm Hebel or similar below appliance)

Failure to install appliance according to these instructions can lead to a fire or explosion. WARNING! Risk of Fire or Explosion!

AS/NZS 2918:2018 4.9.1.
AS/NZS 2918:2018 4.1
AS/NZS 2918:2018 4.9.1(a)
AS/NZS 2918:2018

(AS/NZS 2918:2018)

Installing The Flue
The ue seats over the ue starter spigot, the ue crimp will slide down and rest in the
lower channel. Friction tment secures the ue on the spigot, no sealant required
Lower Channel
Please Note - Flue starter spigot removed from unit for demonstration
purposes only, removal of this spigot is not required during ue installation
Flue seated
correctly

‘
AS/NZS 2918:2018 General Notes

12
Unit Operation

Installing Optional Rear Fans
Optional fans can be installed in two locations depending on how the unit is being
installed, the lower location can be used when the unit is being installed on the
optional base. If you wish to install the unit on raised hearth, the higher fan mounting
location can be used.
Secure fans to
lower mounting
location
Option 2
Raised Hearth
Option 1
Optional Base
Remove panels
and secure fans
to higher mounting
position

Installing Optional Rear Fans
Optional fans require a standard double 240v GPO situated on the wall directly behind
the replace.
Optional fans must not be used within 45 minutes of starting the replace, this allows the
rebox to warm up prior to heat being pulled from the heat exchanger. Using the optional
fans prior will reduce the heat output of the re and delay the warm up process dramatically.
Please Note - Fans must be switched off when the replace door is opened
Failure to do so may result in smoke being blown into the room.