Visonic PowerMax Pro GSM User manual

D-300964 1
POWERMAX PRO GSM
Internal GSM module for PowerMax Pro
Installation Instructions
1. INTRODUCTION
The internal GSM module
enables the PowerMax Pro
system to operate over a
GSM/GPRS cellular
network.
Internal GSM
2. INSTALLATION
1. Open the PowerMax Pro:
1
2
Release
screws
2. Plug in the GSM module and fasten it with the screw:
GSM Front
unit
Warning!
If external antenna
removal is required,
hold its connector (not
the cable) and pull it
out.
This prevents damage
to the P.C.B.
3. Mount the optional GSM external antenna on the
desired site surface, connect its connector to the
internal GSM module and insert the SIM card, as shown
below.
External GSM
antenna cable
(optional)
1
Slide top
cover
Lock cover
to close
6
SIM card insertion
IMPORTANT
1.Before inserting SIM
card, deactivate its
PIN code (by using a
cellular telephone).
2.Do not insert or
remove SIM card
when the control
panel is Powered by
AC power or battery.
4
Slide SIM
card into
cover
5
Rotate cover
to close
2
Open
cover
Align SIM
card in cover
(note cover
orientation)
3
3. DEFINING GSM PARAMETERS
Refer to the PowerMax Pro installer guide section 4.6
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not
returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
VISONIC LTD. (ISRAEL): P.O.B 22020 TEL-AVIV 61220 ISRAEL. PHONE: [phone], FAX: [phone]
VISONIC INC. (U.S.A .): 65 WEST DUDLEY TOWN ROAD, BLOOMFIELD CT. 06002-1376. PHONE: [phone] FAX: [phone]
VISONIC LTD. (UK): 7 COPPERHOUSE COURT, CALDECOTTE, MILTON KEYNES. MK7 8NL. TEL: [phone] FAX: [phone]
INTERNET: www.visonic.com
©VISONIC LTD. 2007 POWERMAX PRO GSM D-300964 (REV. 1, 6/07)