Vivotek AM-713 User manual

Revison History:
Rev. 1.0: Initial release
Rev. 1.1: Added info. for EPoC application.
Rev. 1.2: Added surge protection connection.
VIVOTEK Mounting Accessories
AM-713 Junction Box
Installation Guide
Mounting Dimensions
5.20
51.00 51.00
51.0051.00
Installation
II
Compatible VIVOTEK Cameras
I
Compatible cameras/brackets
FD836B-HTV, FD836B-EHTV, FD836B-HVF2, FD836B-EHVF2, FD8382-TV, FD8382-ETV, FD8382-VF2, FD8382-EVF2, FD9381-HTV,
FD9381-EHTV, FD9371-HTV, FD9371-EHTV
A 3/4" conduit is required for routing the cables with waterproof
connection.
Attach the included alignment sticker to a preferred position. Drill holes
on the wall and install the junction box. If space behind the wall allows,
you may also pass cables through the wall.
Remove the top cover and unhook the tether wire.
NOTE: If you have a POE extender or EPoC device, install them now.
Refer to the later section for details.
Install the cable gland and pass cables through it.
Remove the dome cover and waterproof connectors.
Pass cables through the center hole on the top cover. Secure the
top cover by driving screws.
Pass cables through the routing holes and install the camera to box by
driving screws.
Connect cables to the Ethernet port and terminal block.
1
2
3
4
5
6
7
8
Secure the camera top cover.
9
You can also install a PoE extender (AP-FXC-0200) to the box.
Connect the PoE IN and PoE OUT cables.
Put tags on the cables marking their intended use.
PoE IN
PoE OUT
to another conduit
box
PoE OUT
to camera
Open a live view console and adjust the shooting direction. Refer to the
camera's QIG for more information.
Part no.: 625031302G
Accessory Ordering part no.: 100138700G, AM-713_V01
EPoC junction box part no.: 100201400G
Package Contents
Optional Installation-1
RG6 1.2km
AP-FEX-0106-T
EPoC Tx Module
AW-FCT-050A-250
PoE Switch Indoor EPoC
RG6 1.2km
AP-FEX-0106-T
EPoC Tx Module
Attach a desiccant bag to the inside of the box. Note that the
installation should be completed within 30 minutes so that
desiccant remains effective.

You can also install an EPoC Tx module (AP-FEX-0106-T) to the
box.
PoE OUT
to camera
Optional Installation-2
RG6 1.2km
AP-FEX-0106-T
EPoC Tx Module
AW-FCT-050A-250
PoE Switch Indoor EPoC
RG6 1.2km
AP-FEX-0106-T
EPoC Tx Module
Connect the PoE OUT cable to the camera.
Connect an RG6 coaxial cable to the BNC connector on the module.
Connect a ground wire to a surge protection device using the
grounding hole on the EPoC Tx module so that the device is
protected.
≧20AWG
Surge protection
Equipment enclosure
Equipment grounding
AP-FEX-0106-T
Surge Protection