Vivotek 4X-IP7133 User manual

EN - 1
English
Power off the Network Camera as
soon as it is found smoking or smelt
unusual.
Contact your distributor when such cases
happen.
Keep the Network Camera away from
the water. If the Network Camera is
wet, power off immediately.
Do not place the Network Camera
around the heat sources, such as
television or oven.
Refer to your user's manual for the
operating temperature.
Keep the Network Camera away from
direct sunlight.
Do not place the Network Camera in
high humid environments.
Contact your distributor when such cases
happen.
Warning Before Install

EN - 2
Do not place the Network Camera on
unsteady surfaces.
Do not touch the Network Camera
when it's lightening.
Do not disassemble the Network
Camera.
Do not drop the Network Camera.
Do not insert any object into the
Network Camera, such as needles.

EN - 3
English
Camera stand
IP7133 / IP7134
Warranty card
Screws
Quick installation guide
Power adapter
P
Package Contents
1
Software CD

EN - 4
Network Deployment
3
Physical Description
2
Front panel
Back panel
Status LED PPrivacy button
Lens
Built-in Microphone
ETHERNET
RESET
IO
1234
General I/O
terminal block
Indented reset button
Power cord socket Ethernet 10/100
RJ45 socket
POWER COLLISION
LINK
RECEIVE
PARTITION
12345
3. Connect the supplied power cable
from the camera to a power outlet.
2. Connect the camera to a switch
via Ethernet cable.
●Use Catagory 5 Cross Cable
when Network Camera is directly
connected to PC.
1. If you have external devices such as sensors and alarms,
make connection from general I/O terminal block.
1: Power
2: Digital output
3: Digital input
4: Ground

EN - 5
English
MAC:0002D1533318
Assembled from tested components
Complete system not tested
FCC ID: RRK2005100093
!
IP7133
1. Install the "Installation Wizard 2" under the Software Utility directory from software CD.
2. The program will conduct analyses on your network environment. After your network is
analyzed, please click on the "Next" button to continue the program.
3. The program will search the VIVOTEK Network Devices in the same LAN.
4. After searching, the main installer window will pop up. Click on the MAC that matches the
one labeled on the bottom of your device to connect the Internet Explorer to the Network
Camera.
0002D1533318
Installation
Wizard 2
Assigning IP Address
4
5. Retrieve live video through web browsers or recording software.

EN - 6
For further setup, please refer to user's manual on the software CD.
Configure the Wireless Connection (IP7134 only)
5
1. Check the SSID currently set on your wireless access point (AP).
2. Go to IP7134's Configuration > Wireless LAN.
3. Type in the SSID consistent with the setting on your AP.
4. Select the Wireless mode as "Infrastructure".
5. Click Save. The Network Camera starts to reboot.
POWER COLLISION
LINK
RECEIVE
PARTITION
12345
ADSL/Cable/Hub
AP
6. Wait for the live image is reloaded to your browser. Then, unplug the power cable and
Ethernet cable from the Network Camera.
7. Replug the power cable to the camera. The Network Camera now operates in wireless
mode.
Note:
1. SSID, abbreviated from Service Set Identifier, is the name assigned to the wireless
network. The IP7134's factory SSID setting is set to "default".
2. Select "Ad-Hoc" wireless mode if you want the IP7134 to communicate without using an
AP or wireless router.

P/N:625007400G