Vivotek FD9367-HTV User manual

Revison History:
Rev. 1.0: Initial release
VIVOTEK FD9367-HTV (EPOC)
Installation Guide
Installation
II
5mm
Attach the included alignment sticker to a preferred position. Drill
holes on the wall and if space behind the wall allows, you may also
pass cables through the wall.
Open the top cover using a T10 L wrench.
Keep for later use
Open the included rubber seal grommet and pass the BNC
cable throught it (female to right-angle male BNC connector
cable).
There are two cable routing options: A. through the bottom hole.
B. through the M20 conduit hole on the side.
x3
12
5
A-1
Package Contents
Leave 5mm of screw thread above the wall. This ensures easier
installation using the camera's keyhole slots.
3
Loosen the 3 T10 screws to remove the camera.
Remove the original rubber
seal by loosening 3 T10
screws. Push the seal apart
from the bracket.
A-2
Press the rubber seal assembly into place, and tighten the 3 T10
screws.
x3
A-3
If routing through an M20 conduit, remove the plug and install the
conduit. Route an RG6 coaxial cable through it. The M20 conduit is
user-supplied.
B-1
Loosen the 2 screws securing the AP-FEX-0105-T EPoC module.
Lift it up a bit so that you can connect the BNC connector.
5
Make sure the split on the seal grommet is on the outer side.
Move to Step 5
5
Move to Step 5
Connect the male connector on the cable to the counterpart on the
module. When done, secure the module back in place.
RG6 100m ~ 2.4km
AP-FEX-0105-T
EPoC Tx Module
PoE switch
AP-FEX-0105-R
EPoC Rx Module
RG6 100m ~ 2.4km
AP-FEX-0105-T
EPoC Tx Module
Network switch
AP-FEX-0105-R
EPoC Rx Module
UPoE Injector
Applications
Distance/Power Chart
AP-FEX-0105-T
Length of Coaxial Cable AA-420 65W AP-GIC-011A-095 95W
300m 26.4W 26.4W
500m 17.48W 17.48W
800m 12.63W 12.63W
1000m 8.84W 8.84W
1200m 8.48W 8.48W
1200m ~ 2400m Data only (100Mbps) Data only (100Mbps)
AP-FEX-0200-T
Length of Coaxial Cable AA-420 65W AP-GIC-011A-095 95W
100m 20W per port 20W per port
300m 12W per port 12W per port
500m 8W per port 8W per port
500m ~ 2400m Data only (100Mbps) Data only (100Mbps)
6
M20
Seal ring x 2
Use 2 seal rings when installing the conduit.
B-2
0002D10766AD
XXXXXX
Jot down the camera's MAC address for later reference.
4

Install the camera and top cover back to the base chassis. Please
remember to attach the Ethernet cable between the camera and
the module.
78
Replace the desiccant bag placed inside the chassis.Install the base chassis to the mounting screws you previously
installed by aiming and turning counter-clockwise. When done,
fasten the mounting screws.
9