Vivotek IP7133 User manual

P/N:625007400G

EN - 1
English
Power off the Network Camera as
soon as smoke or unusual odors are
detected.
Contact your distributor in the event of
occurrence.
Keep the Network Camera away
from water. If the Network Camera
becomes wet, power off immediately.
Do not place the Network Camera
around heat sources, such as a
television or oven.
Refer to your user’s manual for the
operating temperature.
Keep the Network Camera away from
direct sunlight.
Do not place the Network Camera in
high humidity environments.
Contact your distributor in the event of
occurrence.
Warning Before Installation

EN - 2
Do not place the Network Camera on
unsteady surfaces.
Do not touch the Network Camera
during a lightning storm.
Do not disassemble the Network
Camera.
Do not drop the Network Camera.
Do not insert sharp or tiny objects
into the Network Camera.

EN - 3
English
Camera Stand
IP7133 / IP7134
Warranty Card
Screws
Quick Installation Guide
Power Adapter
P
Package Contents
1
Software CD

EN - 4
Network Deployment
3
Physical Description
2
Front Panel
Back Panel
Status LED PPrivacy Button
Lens
Built-in Microphone
ETHERNET
RESET
IO
1234 General I/O
Terminal Block
Recessed Reset Button
Power Cord Socket Ethernet 10/100
RJ45 Socket
POWER COLLISION
LINK
RECEIVE
PARTITION
12345
3. Connect the supplied power cable
from the camera to a power outlet.
2. Connect the camera to a switch
via Ethernet cable.
●Use Category 5 Cross Cable
when Network Camera is directly
connected to PC.
1. If you have external devices such as sensors and alarms,
make connections from general I/O terminal block.
1: Power
2: Digital output
3: Digital input
4: Ground

EN - 5
English
MAC:0002D1533318
Assembled from tested components
Complete system not tested
FCC ID: RRK2005100093
!
IP7133
1. Install “Installation Wizard 2” from the Software Utility directory on the software CD.
2. The program will conduct an analysis of your network environment. After your network is
analyzed, please click on the “Next” button to continue the program.
3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network
Cameras on the same LAN.
4. After searching, the main installer window will pop up. Click on the MAC that matches the
one labeled on the bottom of your device to connect to the Network Camera via Internet
Explorer.
0002D1533318
Installation
Wizard 2
Assigning an IP Address
4
5. Retrieve live video through a web browser or recording software.

EN - 6
For further setup, please refer to the user's manual on the software CD.
Configure the Wireless Connection (IP7134 only)
5
1. Check the SSID for your wireless access point (AP).
2. Go to the IP7134 Configuration page > Wireless LAN.
3. Type in the SSID the same as your AP.
4. Select the Wireless mode as "Infrastructure".
5. Click Save. The Network Camera will reboot.
POWER COLLISION
LINK
RECEIVE
PARTITION
12345
ADSL/Cable/Hub
AP
6. Wait for the live image to be reloaded to your browser. Then, unplug the power cable and
Ethernet cable from the Network Camera.
7. Replug the power cable to the camera. The Network Camera will now operate in wireless
mode.
Note:
1. SSID, abbreviated from Service Set Identifier, is the name assigned to the wireless
network. The IP7134 factory SSID setting is set to "default".
2. Select "Ad-Hoc" wireless mode if you want the IP7134 to communicate without using an
AP or wireless router.