Vixen Horns VXS-1050AR User manual

VXS-1050AR
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the entire instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
120V Industrial Electric Motor Siren (Red)
SAFETY INSTRUCTIONS
This product produces a very loud sound, hearing loss or permanent damage may result from improper use.
Do not operate in a closed environment or near pedestrians.
Do not connect the siren to any power source other than that specified above.
Employ equipment for eye protection during drilling operations.
MOUNTING
Identify a suitable area for mounting, preferably an unobstructed steady surface like a pole. Do not attach the
siren to a flexible material.
Using the bracket as a guide estimate and mark the positions for the holes and then perforate to size using a
drill.
Secure the siren to the surface using four screws (not provided).
The specific voltage requirement for this siren is 110-120 volt AC. Therefore installation must be
done with an AC power source of 110-120 volts.

VXS-1050AR
INSTALLATION GUIDE
PAGE 2 of 2
ELECTRICAL CONNECTIONS
Connect the positive wire (RED) of the siren to your 110-120V AC power source and ground the negative
wire (BLUE) of the siren.
To activate the siren install a switch (not included) on the ground wire.
If the siren is being used as part of a smoke detector, gas sensor, timer or anti-theft alarm system, please
follow your device’s instruction.