8
J3905272
Remove the two clips securing the cables to the media player by
first pressing them to the sides and then pulling them away
downwards.
Note!
Be careful with the optic cables so that they are not bent or
stretched.
9A
J3904501
9B
J3904502
Illustration A
Remove the two screws in the lower edge of the existing media
player. Save the screws, they shall be re-used.
Pull out the media player and detach the connectors on the rear
side.
Note!
Make a mental note of how the cables are routed on the rear
side.
Put the media player to one side. It shall not be re
-used.
Illustration B
Take the new media player from the kit, and the two existing
screws.
Note!
Make sure that the fibre optic cable is routed so that it is bent to
a radius of no less than 25 mm (1").
Plug in the connectors to the media player.
Position the media player in the dashboard. Guide in the lug (1) at
the rear edge of the media player using one hand. The lug must
be in the corresponding hole on the reverse of the heater.
Tighten the media player using the two screws.
Reinstall the clips with the cables on the underside of the media
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
