VOO .évasion User manual

Operating instructions
The hard drive for the .évasion box
1/2
This guide describes the instructions for installing the hard drive. The box comes with a pre-installed hard drive and is
ready to be used.
step 1 Locating the hard drive
The hard drive is located on the left side of the box
(when looking at the box from the front), as shown in the
illustration below.
step 2 Ejecting the hard drive
Press rmly on the arrow on the left side of the control
lever. The lever is released on the right.
The protruding part of the lever will be used as a handle
to remove the hard drive.
step 3 Removing the hard drive from the box
To remove the hard drive from the chassis of the box,
grasp the handle between your thumb and forenger
and gently pull the hard drive out of the box.
When the hard drive is partially ejected and the handle is
released, it retracts.
step 4 Removing the new hard drive from
itspackaging
Remove the hard drive from its packaging, and keep
these operating instructions. If possible, recycle the
packaging materials or reuse them if you need to return
the hard drive for repair.
We strongly recommend that you read this entire guide before replacing the .évasion hard drive.
1. Press the power button or standby button (Power/STBY) of the box to switch it off.
2. Disconnect the box by pressing the on/off switch on the back of the device (to do so, turn the switch to “0”).
3. Unplug the power cable of the decoder before proceeding with the following steps.

Operating instructions The hard drive of the .évasion box
2/2
Be sure to insert the hard drive in the right
direction: the strips upwards and the arrow featured
on the lever also facing upwards.
step 7 Locking the hard drive
Depress the hard drive until it clicks.
The hard drive is then inserted properly.
step 8 Turning on the .évasion box
Press the power or standby button.
Your hard drive is ready for use.
step 5 Preparing to insert the hard drive
The hard drive can only be inserted one way.
It is important to note that the hard drive must be
inserted with the strips facing upwards and the arrow
featured on the lever also facing upwards.
step 6 Inserting the hard drive into the slot
of the box
Slide the hard drive into the slot provided for it on the
side of the box. The rails located inside the device will
help you guide the hard drive during insertion.
If you notice any resistance when inserting the
hard drive, do not force it. Make sure that you insert it
properly or that your box does not already contain one.
Find the answers to all the questions related to the .évasion hard drive in the FAQ on our website www.vooassistance.be
or contact us on 078 50 50 50, our technical specialists will be happy to help you.