Vornado 7803 User manual

7803 Stand Assembly Instructions
1.
2.
Surface Preperation
Gently place the unit’s head face down on the
ground. Use a towel or other soft material to avoid
scratching or damaging the unit. Make sure the
surface area is flat.
Installing Tube
Insert power cord into the top of
Tube and pull through the bottom.
Align the Lock Release Button
with the hole located on the Pole
(A). Push the Pole onto the head
until the Lock Release Button
snaps into place.
Lock Release
Button
Top
Bottom

3.
Finished Assembly
Flip fully assembled unit over.
After completing all of the previous steps,
the unit should look like this.
Repeat previous step for the
remainder of the legs.
4.
Installing Legs
To install the legs to
base pole, rotate pole
to vertical position.
Align hole (B), located
on bottom of leg, to
rectangular button on
base of pole (C). Snap
each leg onto pole.