
A
B
CD
E
F
G
DE EN NL FR
Operation and application
When switching the device on, a red control LED on the upper half
of the viewing window lights up for approximately 5 seconds.
After 25 more than seconds, the device is totally ready for
operation.
The motion detector will now be triggered. After a short, acoustic
starting click, the device emits ultrasonic sounds for approximately
9 seconds. The signal lamp behind the motion detector also lights
up red as a visible function control.
The VOSS.sonic 2800 begins to work as soon as the motion detector
is triggered.
The device is now ready for operation.Battery operation
Battery operation
In order to open, push down the cover on the back of the device.
Insert the batteries according to the markings. Then carefully close
the cover again.
The lifetime of the batteries depends on many factors:
Number of releases, use of ash, surrounding temperature.
NOTE: Batteries that are not fully charged cannot release the ash.
This occurs when the voltage (system performance of the 4 batte-
ries) is lower than 3.6 V.
If the voltage drops below 3.4 volts, even the ultrasonic sounds will
not emit precisely enough. The batteries are very weak and have to
be replaced.
Operation - Mains adapter (230 V) (not included in Item-No.: 45340)
The mains adapter included in delivery is splash-proof, robust,
weather-resistant and appropriate for the outdoor use.
When you operate the device using the mains adapter, remove the
moisture prevention cover on the side of the unit and insert the
adapter pin completely.
Betrieb und Anwendung
Loudspeaker
Flashlight / Flash
Viewing window
with motion detector
LED control
On / O-switch &
frequency selection
On / O-switch Flashlight
Mains adapter connection
A
B
C
D
E
F
G