Trouble Shoong
1. Make sure you have put the baeries in correcon direcons, and power switch is
ON.
2. Make sure you have connected the receiver correctly to the computer's USB port.
3. Try another USB port, in case that your USB port is loose.
4. Replace new baeries if needed when the baery power is low.
5. If mouse performance is slow or intermient around a wireless network, unplug
the Nano receiver from the USB port and then re-insert it. To reacvate the mouse,
switch it on, off and on again using the On/Offswitch on the boom of the mouse.
6. Repeat the connecon procedure. You can also try moving the mouse closer to
the Nano receiver.
7. Try other working surface which the mouse is operang on.
8. For the best performance, we suggest that you place the receiver away from other
electrical devices.
Baery Use Reminders
1. Removeworn-out baeries from equipment immediately and dispose of them
properly.
2. Keep all baeries (used or new) out of the reach of children.
3. Never dispose of baeries in fire.
4. Do not mix old and new baeries. Do not mix alkaline, standard (Carbon-Zinc), or
rechargeable (Nickel Cadmium) baeries.
5. Remove the baeries from this device if the device will not be used for a long
period of me.
6. If the performance of the baery decreases substanally, it is me to replace the
baery.
FCC Statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protecon against harmful interference in a residenal installaon.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not occur in a
parcular installaon if this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
To assure connued compliance, any changes or modificaons not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
(Example-use only shielded interface cables when connecting to computer or peripheral
devices).
This symbol on the product or in the instrucons means that your electrical and electronic
equipment should be disposed at the end its life separately from your household waste.
There are separate collecon system for recycling in the EU.
For more informaon, please contact the local authority or your retailer where you
purchased the product.
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTION.
This product uses non-rechargeable alkaline baeries.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference. And
2)
This device must accept any interference received, including interference
that may cause undesired operation.
