VStarcam V3 User manual

可视门铃使用说明书
Video Doorbell User Manual

Video Tutorial
If it is your first time to use our products, it is recommended to scan the
following QR code to watch the video tutorial.

Product Description
IR LED Infrared light
Light Sensor Used to detect environmental brightness
value
PIR Sensor To detect visitors
USB Charge
Port
When the battery is low, no need to take
out the battery, you can connect a DC
5V power adapter to charge the battery
directly.
Lens Video image capture
Microphone Audio capture
Speaker Play voice prompt and voice intercom
Reset Button Press 5 seconds to reset factory settings
Indicator Light Red light flashes every 2 seconds:
The device is waiting for WiFi connection.
: The user has connected The light is red
to the device hotspot.
: The blue light flashes every 0.5 seconds
The device is connecting to the router.
: Device is connected to The light is blue
the router
Light Sensor
PIR Sensor
Indicator Light
USB
Charge Port
Lens
Microphone
Speaker
Reset Button
IR LED

3200mAh lithium batteryBattery
Anti-theft button When someone remove the
doorbell forcibly, anti-theft
button will trigger alarm, it
will send alarm notifications
to the app immeadiately.
Frequency ：433MHZ
Rated voltage：AC110-240V 50/60HZ
Code pairing bu tton
Speaker
Status indica te
light
Anti-theft
Button
Power
Switch

within 2 m
Step 1 : Pre-Setup
Connect your phone to the WiFi network (2.4GHz only).
Place the doorbell within 2 meters
of the router during configuration.
Turn the "power switch" on the back cover of the doorbell to "On" mode.
Reset Button
If it is your first time to connect the device, there is no
need to reset it. If you cannot hear the voice prompt
"Please use APP for WiFi configuration" after the doorbell
is powered on, reset the doorbell.( : Using Reset method
a needle to hold the reset button for about 5 seconds
until you hear the prompt "Reset completed")

Step 2 : APP Download And Registration
1 2
Search for “Eye4”in App Store
or Google Play, or scan the QR
code to download the app.
Click "Register", enter the user name
and password to complete the registration,
and also supports the third party such
as Facebook to login directly.

Step 3: Add Devices To The APP
1Open the app, click the "+" in the upper right corner , and scan the QR code
on the back of the doorbell, then follow the prompts on the app to complete
the adding.(Note: For Android phone, it will pop up some system permission
window, please select "Allow")

2If you can't find the QR code, click the "+" in the upper right corner, select
"Others" --- "Door Cam", select the corresponding model, then follow the
prompts on the app to complete the adding.

You re Done!
Please write down your device information:
When you hear the doorbell prompts "Wireless co
-nnection is successful", wait for about 30 seconds,
the binding page will appear on the app, click "Bind"
to complete the adding.
Eye4 account name:
Eye4 account password:
‘

Hardware Installation Instructions
Note: Please install the device after the configuration is complete.
Install the bottom plate to the doorbell
Stick the doorbell directly on the door
Stick 3M glue on the bottom plate
Method 1
1
2
3
Method 2
Fix the bottom plate with screws
Align the doorbell with the bottom
plate and push the doorbell down
1
2
1 2 31 2 3