Waldorf RN8110GC Instruction Manual

Technical data sheet for
TARGET TOP GAS CONVECTION
OVEN RANGE 900mm
RN8110GC
Heavy-duty cast iron top with removable
centre ring
Matched modular height machined top for
seamless work surface
High output dual ring cast iron burner
GN 2/1 gas convection oven
Drop down door
Stainless steel exterior
Easy clean
Easy service
Fully modular
Controls
• Large easy use control knobs - heat resistant reinforced
• Easy view control settings on knobs
Target top
• Variable high to low burner control
• Single control knob for burner and pilot system
• Flame failure pilot burner
• Manual pilot ignition for reliable operation
Oven
• 50-320˚C thermostatic control
• Indicator lights for power and heating
• Piezo ignition to pilot burner
• Flame failure
• Fan and burner automatic off when door open
Cleaning and Servicing
• Removable oven racking and sole plate
• Easy clean vitreous enamel oven and door inner
• Easy clean stainless steel exterior
• Target Top fully serviceable from front of unit
• Bottom sill removable for burner and pilot access
• Door hinge spring adjustable on unit (door outer removed)
• Door disengages for lift off removal and increased service access
• Access to all parts from front of unit
Overall Construction
• Galvanized steel chassis
• Welded hob surround with 1.5mm 304 stainless steel bull nose
• Splashback and hob sides 1.2mm 304 stainless steel
• Front panels and oven sides 0.9mm 304 stainless steel
• 150mm legs in 63mm dia. heavy-duty 1.2mm 304 stainless steel with
adjustable feet
Target top
• 3 piece heavy-duty cast iron top with fully machined surface
• Top plates and removable centre with integral spill protection design
• Cast top reinforced with integral heat fins for heat zone definition
• 45MJ dual ring cast iron burner with single control
• Full pilot and flame failure protection
• 50mm thick refractory brick lined burner box for high heat retention
• 2 vitreous enamelled spill trays
• Supplied with heavy-duty centre casting removal tool
Oven
• Fully welded and vitreous enamelled oven liner
• GN 2/1 capacity with 4 position racking
• Heavy-duty easy remove heavy wire chrome rack supports
• Cast iron even heat oven sole plate
• 30MJ oven burner
• Pilot and flame failure with piezo ignition
• 100W heavy duty motor
• 200mm diameter heavy-duty circulation fan
• Welded frame drop down door with heavy-duty spring hinge system
• 0.9mm 304 stainless steel door outer
• 1.0mm press formed vitreous enamelled door inner
• High density fibreglass insulated
• Stay cool stainless steel door handle with cast metal handle mounts
• Supplied with two chrome wire oven racks

Australia
Moffat Pty Limited
Victoria/Tasmania
740 Springvale Road
Mulgrave, Victoria 3170
Telephone 03-951 3
Facsimile 03-951 3 33
[email protected]
New South Wales
Telephone [phone]
[email protected]
South Australia
Telephone 03-951 3
[email protected]
Queensland
Telephone [phone]
[email protected]
Western Australia
Telephone [phone]
[email protected]
New Zealand
Moffat Limited
Christchurch
Telephone [phone]
[email protected]
Auckland
Telephone [phone]
[email protected]
Australia
www.moffat.com.au
New Zealand
www.moffat.co.nz
ISO9001
All Waldorf products are designed and
manufactured by Moffat using the
internationally recognised ISO9001 quality
management system covering design
manufacture and final inspection ensuring
consistent high quality at all times.
ISO9001
Quality
Management
Standard
Designed and manufactured by
In line with policy to continually develop and
improve its products Moffat Limited reserves
the right to change specifications and design
without notice.
Technical data sheet for
TARGET TOP GAS CONVECTION
OVEN RANGE 900mm
Specifications
Burners
45MJ dual ring cast iron - Target Top
30MJ tubular - Oven
Gas power
75MJ/hr, 20.8kW
Oven Fan Motor
100W
Electrical requirements
0.13kW
230-240Vac, 50/60hz, 1P+N+E, 0.6A
Target Top
Cooking surface 900mm x 625mm, 5625cm2
Centre 280mm diameter
Maximum plate temperature at centre 500˚C
Oven Dimensions
Width 665mm
Depth 590mm
Height 385mm
Rack size 660mm x 540mm
Rack positions 4
Gas connection
R 3/4(BSP) male
130mm from RH side, 31mm from rear,
and 655mm from floor
Optional underside connection
(refer specification drawing)
All units supplied with Natural and LP gas
regulator
Electrical connection
23mm from RH side, 484mm from rear,
and 150mm from floor
Power cord with 10A 3 pin plug fitted
Dimensions
Width 900mm
Depth 805mm
Height 915mm
Incl. splashback 1130mm
Packing data
1.02m3
Width 940mm
Depth 865mm
Height 1255mm
Gas types
Available in Natural gas and LP gas
Please specify when ordering
Units supplied complete with gas type
conversion kits
Other gas types on request
Options at extra cost
Joining caps
Castors
Plinth mounting
RN8110GC
Printed in New Zealand
© Copyright Moffat Limited
Moffat/4639/BH/1M/8.05