Waring WSCM200MRPC User manual

QUICK START GUIDE
PROFESSIONAL SNOW CONE MAKER
WSCM200MRPC
PARTS
1. Removable snow bin
2. Main housing
3. Ice chute
4. Ice press
5. BPA-free plastic cones (4)
6. Paper cones (12) – not shown
7. Fold-away cone storage
8. Non-skid feet
9. Toggle switch (on/off)
10. Ice scooper
BEFORE FIRST USE
1. Carefully unpack your Waring Pro®Professional
Snow Cone Maker. Remove plastic from all
parts on the unit. Be sure that the unit has not
been damaged during transport. Do not leave
plastic bags around children.
2. Rinse the snow bin with water and a non-
abrasive cleaner, and then dry thoroughly.
OPERATION
1. Place unit on a at, sturdy surface where it will
not be knocked over.
2. Check ice chute for presence of foreign objects
before plugging in.
3. Insert the removable snow bin onto the main
housing. An interlock safety feature will prevent
the unit from turning on if not properly in place.
4. Be sure that the toggle switch is set to the Off
position and plug into an outlet.
5. To begin shaving ice, drop approximately
8-12 ice cubes (depending on size and
shape) into the ice chute. Do not overll or an
interlock safety feature will prevent the shaving
mechanism from turning on. DO NOT ATTEMPT
TO PUSH ICE CUBES INTO BLADE USING
HANDS OR OTHER INSTRUMENTS.
6. Flip the toggle switch to the On position and
rmly push the ice press down to start the ice
shaving mechanism.
NOTE: if a large ice cube should become
lodged in the unit, so that the blades cannot
reach it, ip the toggle switch to the Off
position and unplug from outlet. Empty freshly
shaved snow from the snow bin, place snow
bin back on the main housing, then pour warm
water down the ice chute until lodged ice cube
is melted or falls free. Empty the water from the
2
9
8
3
4
1
5
10
7

QUICK START GUIDE (CONTINUED)
IMPORTANT!
Do not throw away these instructions. READ BEFORE OPERATING your new
Professional Snow Cone Maker. Keep for further reference.
These helpful hints are intended to be a supplement to the Instruction Booklet. In
order to ensure safe operation and optimum performance, please read the entire
Instruction Booklet.
©2012 Waring Consumer Products 11WR127969 PG-29285
snow bin, and dry thoroughly before placing
back on the main housing. Resume feeding ice
cubes through the ice chute.
7. When all the ice has been shaved, turn the unit
to the Off position and unplug.
8. Remove the snow bin from the main housing
and use the ice scooper to shape your snow
cones.
9. Add ingredients specied in the recipe section
or as desired.
HELPFUL HINTS
• Whenshavingmultiplebatchesoficecubes,it
is important to atten the snow in the snow bin.
You will notice a mound of snow is formed directly
under the ice crushing mechanism, and if not
attened this could stop the shaving mechanism
from operating properly. To atten, simply remove
the snow bin and either empty freshly shaved
snow into another container or atten within the
snow bin using the ice scooper.
• Itisimportanttoshaveicecubesfreshfromthe
freezer. Partially melted ice cubes could keep the
shaving mechanism from operating properly. If an
ice cube should become lodged because of this,
please see the NOTE above to release.
• Ifneeded,additionalpaperconesaresoldby
online kitchen and paper suppliers.