WaterTech Pool Blaster User manual

®
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at [phone]
Upgrading the Pool Blaster® MAX Li/MAX Li CG Motor Box
1
Why did my new motor box kit come with a charger?
This complete kit replaces all of the electronics for the Pool
Blaster® MAX Li/MAX Li CG and will guarantee that your
machine will be repaired and increase the longevity of your
battery.
Your old charger will not work. Please dispose of
your original charger.
Your new kit includes:
Motor Box with ON/OFF Button (P30X003LI)
Charger (LC099-3S-US-EU)
There are two sizes of screws used in the
Pool Blaster® MAX Li. While disassembling
the machine, make note of which screw is
used where.
You will need the following tools:
STEP 1: Place the unit on a workbench
with the ON/OFF knob facing up. Unscrew
ON/OFF Knob.
Phillips screwdriver or battery
powered screwdriver and a cutting tool
(set drill at low torque setting)
No cover needed

®
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at [phone]
Upgrading the Pool Blaster® MAX Li/MAX Li CG Motor Box
2
STEP 2: Remove the eight (8) screws from the side of
the shell and separate shell from unit. Place screws to
the side.
The motor box, funnel and pole attachment should
be visable (see below).

®
STEP 3a: Remove the lanyard by
cutting it. Dispose of the lanyard
and knob as they are no longer
needed.
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at [phone]
Upgrading the Pool Blaster® MAX Li/MAX Li CG Motor Box
3
STEP 4: Place the funnel / motor box / pole attachment (currently one
piece) funnel side up, with the pole facing you and extending below the
edge of the table.
STEP 3: Turn the unit over and remove the three (3)
screws holding the opposite shell in place. Separate
shell from unit and place screws to side.

®
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at [phone]
Upgrading the Pool Blaster® MAX Li/MAX Li CG Motor Box
4
STEP 5: Remove the ve (5) screws that hold the
funnel to the motor box and separate the motor box
from the funnel. Place screws to side.
STEP 6: Place new motor box on table with impeller
side up. Place funnel on top of motor box (pole
should be facing you). Line up screw openings on
funnel with screw openings on motor box. Insert
ve (5) previously set aside screws into openings and
tighten with drill or screwdriver.

®
Installation Guide - NiMH to Lithium
Need Help? Contact Customer Care at [phone]
Upgrading the Pool Blaster® MAX Li/MAX Li CG Motor Box
5
STEP 7: Turn the funnel / motor box / pole
attachment on its side (motor box opening facing
away from you). Place shell with three (3) screw
openings onto unit. Insert previously set aside screws
and tighten with drill or screwdriver.
STEP 8: Turn the unit over and reattach the shell
with eight (8) screw openings onto unit. Insert
previously set aside screws into openings and
tighten with drill or screwdriver. Note that there’s
no cover on top of button since the new motor
box is completely sealed.