Watex Aquamatic WX235 User manual

Watex WX235
Aquamatic Drip Watering Kit Installation Manual
1. Aquamatic Timer(Battery not included). 2.15M*4mm Tube 3.4mm T*5PCS 4.Inline Drip*10pcs 5.End Drip*5 pcs
6.Foldable Water Tank

➊ RUN TIME: Rotate the dial to
select the duration of watering
run time you preferred. For
example, in the diagram, the
watering run time is set for
18 minutes.
❶Rotate the Interval Dial to select MANUAL.
❷Rotate Run Time Dial to select watering run time.
❸Press ENTER button to accept the setting,
shortly after it will be started watering for
the duration of selected run time.
For example, in the diagram shown a 2 minutes
watering run time.
Rotate Run Time dial to OFF, then press ENTER.
The timer will stop the MANUAL or AUTO watering.
Note: Once you rotate the dial away from the OFF,
the watering setting resumed without pressing
the ENTER.
❶Press BATTERY CHECK button to check the battery level.
icon ☀○○ mean battery level is low, icon ☀☀○ mean battery level is
medium,icon☀☀☀ mean battery level is full.❷When battery level is low
Aquamatic will begin beeping.❸To stop the beeping: a) Battery change,
removing battery cover and install new 4 AAA(1.5V ) Alkaline batteries.
Make sure battery cover is securely closed. b.) Or to charge rechargeable
batteries by connecting USB cable to the recharge point interface.
(Note: Rechargeable batteries not included)
Beeping Sound
Aquamatic will begin beeping in the two following situations:
❶ When the battery level is low. User can follow steps in (F.) to
change or recharge the batteries.❷ Water level is low. When there
is insufficient water in the water tank, Aquamatic will begin to make
beeping sound to remind user to refill the water.❸Afterbattery charge
or refill water please press “Alert off ” button to stop beeping.
❶Use scissor to cut tubing to the
preferable length.
❷Push down the blue inlet buckle
to connecting/or disconnecting
tubing.
H.Connecting Drip system
For example,
in this setting
Aquamatic
Timer will run
1 8minutes
watering duration
in every 24 hrs.
❸Press ENTER to confirm the setting.
The battery Level lights are flashing
from left to right indicates the setting
is programmed successfully.
❷INTERVAL WATERING: Rotate
the dial to select how long to pass
before the next watering.
For example, in the diagram, an
interval of 24 hours will run the
cycle once every 24 hours.
Use vinyl rain cover to
keep your Aquamatic
dry in the rain.
Waterproof Rain Cover
Watex WX235
Aquamatic Drip Watering Kit Installation Manual