watt box WB-ACC-TRIGGER User manual

INSTALL GUIDE
WB-ACC-TRIGGER
The WattBox Trigger provides users with an easy way to cycle power on any or
all of the outlets on a WB-IP device.
Package Contents
• WattBox Trigger (normally open, momentary closed) switch with adhesive
backing
• Capacitor (buffers the system against stray signals that create a false trigger)
Installation
If your WattBox unit has a service tag (S/T) that ends with the letter “A,” attach the
leads from the included capacitor to the leads from the trigger.
Position the switch in the desired location, then connect to the “REMOTE
TRIGGER” port on the WattBox using the phoenix connector included with the
IP device. Then log into the WB-IP interface to enable the trigger port and select
which outlets to power cycle.
Remote trigger
on the WattBox
Phoenix
connector
Capacitor
Extend wiring
up to 45'/13.7m
using Cat5 or other
conductors 24AWG
or larger. Wires can
be connected either
way (no polarity).
© 2016 Wattbox™

2 Year Warranty
This WattBox™ product has a 2-Year Limited Warranty. The warranty includes
parts and labor repairs on all components found to be defective in material or
workmanship under normal conditions of use. This warranty shall not apply
to products which have been abused, modied, disassembled or improperly
installed. Products to be repaired under this warranty must be returned to
WattBox or a designated service center with prior notication and an assigned
return authorization number (RA).
Technical Support
Phone: [phone]
Email: [e-mail]
160922-1249