WaveSplitter WST-PEX004 User manual

Copyright © 2020 Wavesplitter AV Technology |Wavesplitter .com
TEL：[phone] MAIL：[e-mail]
OPERATION MANUAL
Model No. WST-PEX004
50M HDMI 1080P PoC & IR over Single Cate.5/6 Extender with Loop out
Safety Instruction

Copyright © 2020 Wavesplitter AV Technology |Wavesplitter .com
TEL：[phone] MAIL：[e-mail]
OPERATION MANUAL
Introduction
The WST-PEX004 is a simple to use plug and play solution which lets the user extend HDMI signals up to 50m using a single low
cost Cat.6 U/UTP cable (not included). For added convenience IR signals (20-60 kHz) can also be extended using the supplied IR
Receiver and Emitter cables.
Supporting resolutions up to Full HD 1920x1080P@60Hz, video content can be seen with incredible clarity at distances up to 50m,
perfect for use in a variety of AV and digital signage applications in a range of settings.
The Extender features an HDMI loop-through output on the Transmitter with simultaneous viewing so that a local display can be
connected for monitoring or to create an additional viewing zone. To ensure the maximum compatibility when two displays are
connected, the EDID data, which determines the supported video and audio formats, can be used from either a local monitor
connected to the Transmitter or the remote monitor connected to the Receiver.
Power over Cat.6 (PoC) functionality enables the Extender to operate from a single power supply connected to the Transmitter,
allowing the Receiver to be located where there is limited access to mains power sockets making it ideal for retro fit installations.
Key Feature
Each set includes one transmitter with loop out and one receiver.
Audio sampling rate up to 48KHz, support 7.1 channels.
Support 1080P@60Hz YUV4:4:4 Maximum extension of 50m.
DC12V/1A, support PoC power supply.
RX end one-way infrared transmission to TX end.
Copy local and remote EDID functions.
Setting of distance extension dialing switch: cat5e/cat6 10m～50m.
Support Dolby®、TrueHD、DTS-HD®、Master Audio™.
Package Content
Transmitter x 1 | Receiver x 1 | 12V/1.25A Multi-Country Power adapter x 1 | IR Emitter x 1 | IR Receiver x 1
Panel Description
EQ DIP Switch
000
1~15meters network cable distance
011
16~30meters network cable distance
101
31~40meters network cable distance
111
41~50meters network cable distance
Note :
Its receiver has 3 bit dialing switch.
From left to right, 1 is the high position, 3 is the low
position, Corresponding to binary, dial up to 0, dial down
to 1, for the extension cord distance adjustment.
Different network cable lengths need to be set according
to the following table.
※When the distance up to 41~50m, please make sure the UTP cable up to 24AWG.

Copyright © 2020 Wavesplitter AV Technology |Wavesplitter .com
TEL：[phone] MAIL：[e-mail]
OPERATION MANUAL
Application
Connecting and operating
1. Connect 1 source such as a Blu-Ray Player, game console, STB, etc. to the HDMI input on the transmitter．
2. Connect 1 display such as an HDTV or HD Projector to the Loop HDMI output on the transmitter.
3. Connect 1 display such as an HDTV or HD Projector to the HDMI output on the receiver．
4. Connect a single Category 5e / 6 / 7 up to (50m) to both transmitter and receiver.
5. Plug in the IR-RX cable and IR-TX cable to the IR jack port located on the Receiver and transmitter banal.
6. Power on the transmitter firstly, then power on the source and sink.

Copyright © 2020 Wavesplitter AV Technology |Wavesplitter .com
TEL：[phone] MAIL：[e-mail]
OPERATION MANUAL
Specification
Interface
Transmitter
Input
HDMI Type-A (Female) x 1
Output
HDMI Loop out Type-A (Female) x 1
RJ45 (Female) x 1
IR-Out slot x 1
Receiver
Input
RJ45 (Female) x 1
IR-In slot x 1
Output
HDMI Type-A (Female) x 1
Transmission
HDMI Compliance
HDMI 1.3a (DVI 1.0)
HDCP Compliance
1.4
Input Video Signal
0.5-1.0 Volts P-P
Input DDC Signal
5 volts p-p (TTL)
Output Signal
HDMI
Output Resolution(Max.)
1920x1080P@60Hz
Audio Format
Dolby®、TrueHD、DTS-HD®、Master Audio™, multi-channel 7.1, stereo etc
IR Frequency
38-56KHz
Power
Power Supply
12V/1.25A DC
Max Power Consumption
15W
Environment
Operating Temperature
-5˚C～40˚C
Storage Temperature
-20˚C～60˚C
Product Structure
Main Material
Metal
Size W x D X H
TX : 79 x 68 x 17mm | RX : 79 x 68 x 17mm
Weight
TX : 120g | RX : 115g
Country of Origin
China
Certification
Safety & Emission
CE / FCC / ROHS / RECAH