Wenger Keyboard Mount User manual

Assembly Instructions
Keyboard Mount Accessory
for Flex
®
TechBridge
©Wenger Corporation 2019 Printed in USA 2019-10 Part #236A184-02
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 4WENGER (493-6437) • Worldwide: [phone] • wengercorp.com
Parts List
Keyboard Mount
Accessory
Note: Please read and understand these instructions before assembling.
Note: If you need additional information, contact Wenger Corporation using the information below.
Basic Instructions to be used with the Keyboard Mount Accessory for Flex® TechBridge only!
For othe component information, refer to the Flex TechBridge Owner's Manual 236A153.
Item Qty Description Item Qty Description
14Self-Adhesive Pad 4 2 Bridge Clip
22Keyboard Mount Bar 5 2 Socket Screw, 3/8-16 x 3/4"
32Keyboard Mount Plate 6 2 Jam Nut, 3/8-16
2
3
4
5
6
1

Assembly
1. Attach a keyboard mount bar (2)
to a bridge clip (4) using one
3/8-16 x 3/4" socket screw (5),
one keyboard mount plate (3)
and one 3/8-16 jam nut (6).
a. Tighten until the keyboard mount bar
cannot rotate, then loosen the
jam nut until the keyboard mount bar
can be rotated, but still has enough
friction to stay in place when positioned.
b. Repeat this step for the other
keyboard mount bar assembly.
2. Apply two self-adhesive pads (1)
to each keyboard mount bar as shown.
 Peelo󰀨theprotectivepaperlayer
and press the pads onto the bar.
2
Note the orientation
of the keyboard mount bar lip and
the longer edge of the bridge clip
Note the keyboard mount plate
hole orientation
Keyboard
Mount Bar
(2)
Keyboard
Mount Plate
(3)
Bridge
Clip
(4)
3/8-16 x 3/4"
Socket Screw
(5)
3/8-16
Jam Nut
(6)
Self-Adhesive
Pads
(1)
Bridge
Extrusion
Assembled
Keyboard Mount
Release
Handle
3. Attach the assembled keyboard mounts to the
bridge extrusion by inserting the short sides
of the bridge clips into the outside groove.
Press down to snap the long sides of the
bridge clips into place.
4. Place the keyboard on the mounts and rotate
the support bars until they wedge against the
keyboard to hold it in place.
5. To reposition or remove the keyboard mounts,
release the bridge clips by pulling on the
release handle (long side of the clip) and
rotate forward.
Assembled
Keyboard Mount
Release
Handle