Wenger Work Surface Mount User manual

Assembly Instructions
Work Surface Mount Accessory
for Flex
®
TechBridge
©Wenger Corporation 2019 Printed in USA 2019-10 Part #236A183-02
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 4WENGER (493-6437) • Worldwide: [phone] • wengercorp.com
Parts List
Work Surface Mount
Accessory
Note: Please read and understand these instructions before assembling.
Note: If you need additional information, contact Wenger Corporation using the information below.
Basic Instructions to be used with the Work Surface Mount Accessory for Flex® TechBridge only!
For othe component information, refer to the Flex TechBridge Owner's Manual 236A153.
Item Qty Description Item Qty Description
11Work Surface 3 4 Screw, #10-3/4”
22Bridge Clip 4 4 Flat Washer, 0.188 ID x 0.734 OD
234
1

4. Attach the assembled work surface mount
to the bridge extrusion by inserting
the short sides of the bridge clips
into the outside groove.
Press down to snap the long sides
of the bridge clips into place.
5. To reposition or remove the work surface mount,
release the bridge clips by pulling on the
release handle (long side of the clip) and
rotate forward.
Assembly
1. Align the bridge clip (2) with the pilot holes
located at the bottom side of the work surface (1)
and attach it using two #10-3/4” screws (3)
and 0.188 ID x 0.734 OD at washers (4)
as shown.
2. Repeat to attach the second bridge clip.
2
Note the location of
the Wenger logo and
the longer edge of
the bridge clips
Work
Surface
(1)
Bridge
Clip
(2)
#10 x 3/4"
Screws
(3)
0.188 ID x 0.734 OD
Flat Washers
(4)
Bridge
Extrusion
Assembled Work
Surface Mount
Release
Handle
Always load the
work surface evenly.
!CAUTION
Release
Handle