Wenger Laptop Mount User manual

Assembly Instructions
Laptop Mount Accessory
for Flex®echBridge
©Wenger Corporation 2014 Printed in USA 07/14 Part #236A185-01
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, innesota 55060-0448
Questions? Call.....USA: 800-4WENGER (493-6437) • Worldwide: 1-507-455-4100 • www.wengercorp.com
Make sure that anyone working
with the Flex TechBridge &
Accessories has read and
understands these instructions.
!CAUTION
Failure to comply with Warnings
and Cautions in this document
can result in damage to
property or serious injury.
!CAUTION
PAR S LIS
Item Qty Description Item Qty Description
1 1 Laptop Z-Lift 4 4 achine Screw, #10-24 x 5/8”
2 2 Bridge Clip 5 4 Nylon Lock Nut, #10-24
3 2 Laptop ount Clamp 6 4 Flat Washer, .188 ID x .734 OD
1
23
4
5
6

2
ASSEMBLY
1. Attach one Laptop ount Clamp to a
Bridge Clip with a #10-24 x 5/8"
achine Screw, Flat Washer and
#10-24 Nylon Lock Nut.
Repeat this step to assemble another
Laptop ount.
Note: The Laptop ount Clamps on
each Bridge Clip must face in opposite
directions when attached to the clips.
2. Slide the open end of the Laptop ount Clamp onto the underside of the Laptop Z-Lift Frame.
3. Position the Laptop ount in the desired location.
4. Attach the Laptop ount Assembly to the Bridge Extrusion
by inserting the short sides of the clips into the outside
groove of the bridge extrusion.
Then press down to snap long sides of the clips into place.
5. To reposition or remove Laptop ount, release the clips
by pulling on the Release Handle (long side of the clip)
and rotate the Laptop ount Assembly forward.
Plug the USB cable into a USB port on the
laptop computer (not supplied) to energize the
cooling fan and the auxiliary USB parts of the
Laptop ount.
Laptop Mount
Clamps
Laptop
Z-Lift
Bridge
Extrusion
Laptop Mount
Assembly
Release
Handle
#10-24 x 5/8”
Machine Screws
Laptop Mount
Clamps
Bridge Clip
.188 ID x .734 OD
Flat Washer
#10-24 Nylon
Lock Nut