Western Telematic Net Reach RPC-4840N User manual

western telematic incorporated
Telnet and Dial-Up -48V DC Power Switch
Remote
Power Control
For High Amperage
Switches and
Routers!
Features:
■
Dual -48V DC
40 Amp Circuits
■
On/Off/Reboot Switching
■
Integral 10Base-T
Interface
■
RS232 Modem and
Console Ports
■
Outlet-Specific
Password Security
■
Network Security
Features
Electronic equipment sometimes "locks-up", requiring a service call just
to flip the power switch to do a simple reboot. The Telnet Power Switch
gives you the ability to perform this function from anywhere on the
LAN/WAN, or if the network is down, to simply dial-in from a modem for
out-of-band control.
Intelligent Power Control
The RPC can communicate over any TCP/IP network using standard Telnet,
or out-of-band using an external modem and basic VT100 type terminal
emulation. Each outlet can be assigned an individual password, device
name, reboot delay time and unique power-up default state.
RPC-4840N
Heavy Duty DC Network Power Switch
NETREACH™
Solutions for Remote Network Management
0102-RPC4840-1
DC
POWER
DC
POWER
POWER
SOURCE
A
POWER
SOURCE
BRMM RACK MODEM
REMOTE
ADMINISTRATOR
PSTN
DIAL UP
WAN
TELNET
RPC-484ON
POWER
SUPPLY
A
POWER
SUPPLY
B
ROUTER

Reliability and Support
The RPC is built in the USA and backed by a two year factory warranty.
NetReachTM products are installed in thousands of network sites world
wide. Our customers know they can depend on superior quality and
reliability for their most mission-critical operations.
Security Features
Address-Specific IP security masks prevent unauthorized sources
accessing the RPC menu through the network. The RPC provides two
levels of operational passwords; the system administrator level, which
allows access to all configuration and switching functions, and the user
level which only allows switching of assigned plugs.
Easy to Configure, Easy to Use
The RPC can be configured over the network, via modem or locally
via the console port. Easy to use commands let you assign a location
name, set system parameters and view plug status. Outlets can be
switched On, Off or Booted using plug numbers or names.
Specifications
Power Input/Output: RPC-4840N
(-48V DC)
DC Inputs: Two (2)Bus A & B
Voltage: -48V DC
Connector: Block (2)#8 Screws
Load: 40 Amps Each Bus
Modem and Console Port Interface:
Connector: DB9M, RS232C, DTE
Coding: Serial ASCII, 8 bits, No Parity
Physical / Environmental:
LED Indicators: ON, RDY, RXD,
Outlet ON (1-2)
Size: 3.5"H x 19"W x 7.5"D - (2RU)
Weight: 10 Lbs. Shipping Weight
Operating Temperature: 32°F to 122°F
Humidity: 10 - 90% RH,
Non-Condensing
Model Identification:
RPC-4840N: Network Power Switch
Administrator Status Display
Circuit Breakers 10Base-T Ethernet
Interface 19”Rack Brackets
Dual Power Bus Modem Port for
Out-of-Band
Management Local RS232
Console Port
RPC-4840N Heavy Duty DC Network Power Switch
western telematic incorporated
5 Sterling •Irvine •California 92618-2517
TOLL FREE [phone]
TEL [phone]
FAX [phone]
EMAIL [email protected]
WEB www.wti.com
© Copyright 2002 Western Telematic, Incorporated
NetReach is a trademark of
Western Telematic, Incorporated