Westgate DV62 User manual

Log Set Installation
DV62
SHERWOOD INDUSTRIES LTD
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
This publication is intended as a
guide for installers to help with the
assembly of the log set only.
Please refer to the Westgate DV62
Owner’s Manual for specic, detailed
and complete information on
installation and operation.

Log Set InStaLLatIon:
1. Install Log #8. Place the locating groove on the rear end of log #8 onto the grate. Insert the pin hole
on the front end of log #8 into the pin tab at the center of the grate
Each log is numbered 1 through 10 to assist in the log set assembly. (Logs are not assembled in # sequence.)
2
9
4
10
7
586
3
1
8 8 Locating
Hole
Groove
Grate Pin Tab

8
7
7
9
9
9
Log #8 in position 2. Install Log #7. Place the locating groove on the
rear end of log #7 onto the grate.
Groove
Locating
Groove
Fits Here
Log
Rests
Here
Ridge
Lean the front end of Log #7 up against the ridge
on Log #8.
8
Locating
Hole
Pin Tab
3. Install Log #9. Place the locating hole on the left
side of log #9 onto the locating pin on the grate.
Place the right side of Log #9 onto the at surface on
the rear of Log #7.
7
Log #9 in position

99
5
5
5
Log #9 in position The bottom of Log #9 should be parallel to
the top of the riser.
4. Install Log #5. Fit the 2 locating grooves on Log #5 onto the 2 tabs on the left side of the grate.
Groove 1
Tab 1
Groove 2
Log #5 in position
Tab 2

6
6
6 6
6
5. Install Log #6. Fit the 2 locating grooves on Log #5 onto the 2 tabs on the right side of the grate.
Groove 1
Tab 1
Groove 2
Tab 2
Log #6 in position

10
2 2
2
Notch
6. Install Log #10. Fit the rear of Log #10 onto the
groove at the rear of Log #8. Place the front of Log
#10 onto the notch in Log #7.
7
Groove
8
7. Install Log #2. Place the bottom of Log #2 onto the
grate.
Log #2 in position
Groove
Grate
Rest the top of Log #2 onto Log #9.
9

8. Install Log #1. Place the groove on the bottom of
Log #1 onto the grate.
4
4
9. Install Log #4. Place the groove on the bottom
of Log #4 onto the grate.
Groove
Grate
Place the top of Log #4 into the groove of Log #10
1
1
Rest the top of Log #1 onto Log #9.
Groove
Grate
10
Groove
9

3
4
3
Log #4 in position 10. Install Log #3. Place the groove on the bottom
of Log #3 onto the grate. Rest the top of Log
#3 onto the logs behind it.
Log #3 in position
Grate
6
Groove

Completed Log Set