655
645
636
617
625
616
615
614
613SC
665
P615
P617
P618
P627
FUNCTION TEMP
Hold 3s
BACK FAVOURITE
SET TIME
ALARM OK
ON/OFF
16:30
00:15 140°C
Installing the oven accessories
1. Install telescopic slides (where supplied) to the
side racks. Refer to installation guide supplied
with oven slides.
2. Insert side racks
There is a left hand and right hand version (see image).
1. Insert the rear peg into the rear access hole,
ensuring that the peg is fully inserted.
2. Then locate the front peg into the front access hole
and push in firmly.
Set... Left hand side rack
front peg rear peg
4. Fit shelf/tray (where
supplied) to telescopic slides
1. Push the shelf or tray along
the top of the slide until it hits
the back post.
Shelf Back post
2. Drop the front of the shelf or
tray onto the slide ensuring it
sits behind the front post of the
slide.
Shelf
Front post
3. When fully inserted the shelf/
tray should not interfere with
the closed oven door.
3. To fit a shelf or tray to side racks:
1. Locate the rear edge of the shelf
in between guide rails of the
side rack. Ensure the same rail
positions on both sides of the
oven are being engaged.
2. With the front edge raised, slide
the shelf into the oven.
3. Once the detents have passed the
front edge of the side rack, the
shelf can be pushed completely in.
Detent
Condition the oven (to burn o
any residue)
New appliances can have oil or
residue left from manufacturing.
You will need to heat your oven
for 30 minutes before using it for
the first time.
1. Press ON/OFF and select
‘Fan Bake’ function using
or symbols.
2. Press OK.
3. Press or symbols to
set the oven at 180°C for
approximately 30 minutes.
Please ensure that the room
is well ventilated during this
process.
Set the time
You must set the time before you can operate your appliance.
1. After the appliance has been electrically connected, press
ON/OFF to turn ON
2. To set the time, press until “Settings”
is highlighted and press OK
3. Then, “Set time of day” is highlighted
and press OK
4. Press or to set the hour and minutes press OK
5. Press BACK to return to function menu
NOTE: The clock has a 24-hour display
