5NUD9Westward Operating Instructions and Parts Manual
Grease Filler Pump
General Safety Information
Always wear safety glasses when using grease pump.
Keep work area clean and remove any excess grease
from tools, hands, and clothing after use.
If excess grease is left on floors,
tools, or equipment, a slippery surface will be
created.
Never use this pump with water
based fluids, chemicals and acids
Do not use steel follower plate when using the
pump with tapered grease containers. (Only use
rubber follower plate with tapered containers).
NOTE: The pump is made from plated steel
components. It should never be used to transfer fluids
that may cause the pump to rust.
Pump comes complete with a female loader
fitting to adapt to the loader valve fitted on
grease guns, drum cover, and follower plate.
Assembly
1. Insert the pump assembly through the flange
fitted on the drum cover.
Note: Do not tighten the nut and screw to clamp the
tube assembly with drum cover.
2. Insert the follower plate in grease container.
Push down firmly onto the grease until grease
emerges through the rubber grommet. (fig 2)
3. Insert the pump tube assembly along with the drum
cover through the rubber grommet of follower plate, till
the pump tube touches the base of the container (fig 3).
4. Adjust the drum cover on the pump tube assembly
to ensure it seats firmly on to the rim of grease
container.
5. Hand tighten the 3 thumb screws on the drum
cover assembly to affix the drum cover firmly to the
grease container
Note: Take care to tighten the thumb screws evenly
on to the grease container.
6. Tighten the nut and screw on the flange of the
drum cover to hold the tube assembly firmly in place.
Note: Do not over tighten the nut and screw
assembly.
7. Screw the grease bend pipe and filler adapter
assembly on to the outlet at the pump head.
8. Pour approx 30ml of oil (SAE 30) into the pump
outlet and start operating the lever handle. In a few
strokes, pump will start dispensing grease.
Wetted components
Steel, Aluminum, Zinc, Brass, NBR, PVC
Recommended Use
For Grease upto &v including NLGI 2
Do not use with
Water based & other corrosive media
Never exert under pressure on
Lever handle
(Figure 2) (Figure 3)
Warranty
LIMITED ONE-YEAR WARRANTY
Should this product fail to perform satisfactorily due to a defect or poor workmanship within ONE YEAR from the date
of purchase, return it to the place of purchase and it will be replaced, free of charge. Incidental or consequential
damages are excluded from this warranty.
2
