Whirlpool LE7680XP User manual

AUTOMATIC
DRYERS
Electric Model
LE7680XP
and
Gas Model
LG7681XP
.%aare Ovens. Trash Compactors. Room AH Condllloners. Oehumldlflers. Aulomattc Washers, Clothes Dryers. Freezers, Refrl%erator-Freezer!

Parts and features
CYCLE CONTROL LAUNDRY
KNOB /INFORMATION CENTER
TURE SELECTOR
--~ I-
/-y-y DRYER DRUM
I/
Remove the Con-
sumer Buy Guide lo-
bel before using
your dryer. It will be
easier to remove.
Wipe out the
dryer drum with a
damp cloth to re-
move dust from stor-
ing or shipping.
Copy your Model and Serial Numlm)ers here
When you need service or call with a -
question, have this information ready.
Co lplete Model Number
1. Complete Model and Serial Numbers
(from the plate located 05 shown)
2. Purchase dote from soles slip. ~0 ,p,ete Ser,o, Number
Copy this information in these spaces. -
Keep this book, your warranty, soles slip
Pur hose Date
and “Dryer Guide” in the Laundry Infor-
motion Center on the bock of the dryer % Ice Company and
console.
Telt phone Number
There is no warranty regislrotion to return P Iof-of-purchase is all
that is required for in-warranty service.
Contents Page
-2
3
3
PARTS AND FEATURES
YOUR RESPONSIBILITIES.
SAFETY FIRST.
SELECTING A CYCLE AND
STARTING YOUR DRYER.
OPERATING INSTRUCTIONS,
Automatic Cycles
Timed Drying
DRYING TIPS. .
FLUFFAIR Setting
TUMBLE PRESS@Setting
Gentle Heat , . .
Drying Times.
Mixed .oads
End-ot SycleSignal
Lint Si(; ial
LINT SCREEN
LINT REM OVAL
CARING FOR YOUR DRYER.
IF YOU NLiED SERVICE OR
ASSISTAHCE
1. Befc: ‘e Calling for
Assi: tance
2. IfYol I Need Assistance
3. IfYol I Need Service
4. IfYol IHave a Problem
Page
8
:
9
9
10
01985 Whirlpool Corporc: Ition

i I
Your
Responsibilities
Read this “Use and Care Guide”
and your “Dryer Guide” carefully for
important use and safety information.
You are personally responsible for
making sure that Your dryer...
l is installed by a qualified installer.
l is properly maintained.
l is installed in an area protected
from the weather.
l is properly installed and leveled in
a well ventilated room* on a floor
that can support the weight.
l is located in an area where the tem-
perature is above 45°F (7.2”C).
l is connected to the right kind of out-
let, electric supply and grounding.*
l is properly connected to fuel and
exhaust systems.*
l is used only for jobs normally ex-
pected of home clothes dryers.
l is not run where there may be explo-
sive fumes.
. is not used by children or anyone
unable to operate it properly.
‘See the “Installation Instructions” for
complete information.

S’iJGGESTED SUGGESTED
TYPE OF LOAD CYCLE TEMPERATURE
COTTONS - LINENS
EXTRA HEAVY - Bedspreads, HEAVY
mattress pads,quilts. HIGH
HEAVYWEIGHT FABRICS - Towels,
jeans, corduroys, work clothes AUTOMATIC PERMIErESS
MEDIUMWEIGHT COTTONS - REGULAR
Sheets, pillowcases, cotton
underwear,diapers KNITS GENTLE
LIGHTWEIGHT COTTONS - Batistes, LOW
organdies, lingerie
PERMANENT PRESS, SYNTHETICS
AND BLENDS
HEAVYWEIGHT FABRICS -Work clothes, PERMIT PRESS
AUTOMATIC MED
jacket&raincoats . PERMANENT
MEDIUMWEIGHT FABRICS - Shirts, play PRESS
clothessheets. slacks
LIGHTWEIGHT FABRICS -Lingerie, MED
blouses, dresses LOW
KNITS
HEAVYWEIGHT - Cottons, rayons,
blendsl-shirtsslacks. shirts P,FRMANENT
Pl.UTOMATlC MED LOW
LIGHTWEIGHT - Synthetics (polyester, PRESS
acrylic, etc.) and blends, lingerie, KNITS GENTLE
blouses, dresses LOW
LIGHTWEIGHT AND DELICATE FABRICS AUTOMATIC
Sheer Curtains (2 or 3 panels) PliRFR;fNT Ex
Gauze, lace, etc. LOW
RUBBER, PLASTIC, HEAT-SENSITIVE TIMED
FABRICS DRYING
FOAM RUBBER - Pillows, bras,
stuffed toys 2 3-30 MINS. FLUFF
PLASTIC - Shower curtains, AIR
tablecloths 2 3-30 MINS.
RUBBER-BACKED RUGS 4 3-50 MINS.
OLEFIN. POLYPROPYLENE. SHEER NYLON Iii-20 MINS.

Select a
1. CYCLE Set TEMPERATURE
2. SELECTOR
Turn the Control Knob either way to
point to the cycle and setting you
want. See page 6 for information on
the cycles.
Push the
3. START Button
The dryer will start tumbling when
you push the START Button.
The Temperature Selector can be
set on any desired drying tem-
perature or anywhere between two
temperatures.
To stop and restart
the dryer
To stop the dryer, open the door (or
turn the Control Knob to OFF).
To restart the dryer, close the door,
SeleCt Cycle, if necessary, and push
START.
The Cycle Control Knob should point to OFF when the dryer is not in use.

Operating instructions
The automatic cycles
The automatic cycles allow you
to select the degree of dryness you
prefer for the clothes being dried.
The Control Knob moves and stops
several times until the load reaches
the dryness setting you selected Then
the knob automatically moves to
OFF and tumbling stops.
weight cotton items. The load tum-
bles without heat during the last 5
minutes. This helps make the load
easier to handle.
Use
AUTOMATIC
PERMANENT
PRESSto dry
permanent
press, knits and othersynthetic;ab-
rics. The load tumbles without heat
during the last 10 minutes.This helps
keep wrinkles from setting in.
For the first few loads, set the Control
Knob to ooint to an* in either auto-
matic c scle. When the dryer stops,
feel the jried items.
l If items are drier than you like, use
a settir g to the right of the* the next
time yc iu dry a similar load.
l If item: are not as dry as you like,
use a :i9ting to the left of the *the
next tir’le you dry a similar load.
Timeddrying
Use the TIMED DRYING Cycle for
any load you want to dry by time. For
example: small loads, large bulky
items, items to be fluffed or dusted
with the FLUFFAIR heat setting.
l Turn the Control Knob to the number
of minutes you want - from 10 to 60.
9 The last 5 minutes of this cycle are
without heat - a cool-down time. This
helps make the load easier to
handle.
6

I
I’
Drying tips
TUMBLEPRESS@ Setting
The dryer does not heat when the The TUMBLE PRESSsetting removes
Control Knob is set on FLUFFAIR. This wrinkles from dry clothing such as
setting can be used to fluff bedding, items that may have been packed
plastic tablecloths, foam rubber pil- in a suitcase, closet, or items not
lows, stuffed toys, sneakers, etc. removed from the dryer.
1. Turn the Control Knob to the number 1. Set Control Knob to TUMBLE PRESS.
of minutes you want in FLUFFAIR. 2. Set Temperature Selector to PERM’T
2. Push the STARTButton. PRESS/ MED
3. Push START Button.
The load will tumble in heated air
for 10 minutes. The heat shuts off and
the dryer continues to tumble the
load for 5 more minutes.
For best results, TUMBLE PRESSonly
a few items at a time. Put them on
hangers or fold them as soon as the
dryer stops.
Gentle Heat
The dryer automatically reduces the
heat setting in HEAVY HIGH and PERMIT
PRESSMED cycles. The last 7 minutes
of each of these cycles gradually
reduces the dryer temperature to a
lower heat setting. This helps prevent
over drying.

Drying times Mixed loads
Drying times will vary depending on
l amount of moisture in the clothes.
l type and weight of the fabric.
l size of the load.
l room temperature around the
dryer.
l temperature of the wash rinse
water.
l amount of lint in the lint screen.
l dryer temperature selection
See page 6 in your “Dryer Guide”
for more information.
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest fab-
rics When the dryer stops, remove
dry items and reset the control.
End-of-cycle signal The dryer sounds a signal to let you know
3
when the cycle is finished.The signal cannot be
P
‘/ turned off and is not adjustable.
The signal is helpful when you are drying
permanent press, synthetics and other items
’ T stops
that should be taken out as soon as the dryer
\’
tint signal
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The [whistle tone) signal lets you know
the air flow is being restricted. Restricted air flow
reduces drying efficiency.
Turn off the dryer and clean the lint screen as
shown on page 9.
0
c__-I;

Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIRE HAZARD.
Open the lid and pull the lint screen ROLL the lint off the &creen
with your fingers.
DO NOT rinse or wash the screen.
Push the screen firmly back into
place.
Lint removal
Lint can gather inside the dryer and create a fire hazard.This lint
should be removed every 2 to 3 years, or more otlen, depending on
dryer usage.
ELECTRIC DRYERS GAS DRYERS
Cleaning should be done only by a qualified person.
0
l Avoid electrical shock
hazard - unplug power
supply cord or turn off
electrical power.
’ Avoid injury or damage - do not
put hands inside cabinet.
’ Make sure dryer is cool.
1. Remove back panel (electric)
or lower access panel (gas].
2. Avoid damaging wires,
thermostats, funnel or igniter.
3. Remove lint from shaded area -
see art - with a soft brush or
vacuum cleaner.
4. Replace panel; reconnect and
re-level dryer.

II’
Caring for your dryer
Remove sharp objects from clothing
before drying - pins, bucklesetc.
Close metal zippers.
Wipe off all spills with a damp, soft
cloth.Spills allowed to remain may
dull or damage the finish.
Never leave wet or damp laundry in
your dryer.
Sharp or heavy objects should
never be put on or in the dryer.
Check pockets for bolts, nuts, etc.
Non-colorfast items can stain the
drum. Wipe carefully after drying to
make sure there is no dye to be
transferred to items in the next load.
Some pretreatment products can
damage dials, console and finish. Do
not use these products on or near
your dryer.
Vacation care
Unplug power cord or For gas dryers, close Clean lint screen
turn off electrical power. gas valve.
10