Whirlpool LE7OlOXP User manual

-
\
\
AUTOMATIC
DRYERS
Electric Model
LE7OlOXP
and
Gas Model
LG7OIlXP
wave Ovens Trash Compactors Room Air Condltloners Oehumldllwrs Automallc Washers Clothes Oryerr Freezers Refrl$erator-Freeze'

Parts and features
CYCLE CONTROL KNOB
CENTER
RE SELECTOR
START BUTTON
LINT SCREEN
LOADING DOOR
Remove the Con-
sumer Buy Guide la-
bel before using
your dryer. It will be
easier to remove.
Wipe out the
dryer drum with a
damp cloth to re-
move dust from stor-
ing or shipping.
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
Complete Model Number
I. Complete Model and Serial Numbers
(from-the plate located as shown)
2. Purchase date from sales slip.
Complete Serial Number
Copy this information in these spaces.
Keep this book, your warranty, sales slip
Purchase Dote
and “Dryer Guide” in the Laundry Infor-
mation Center on the back of the dryer
Service Company and
console. Telephone Number
Contents
Page Page
-2
3
3
PARTS AND FEATURES
YOUR RESPONSlBlLltlES
SAFETY FIRST
SELECTING A CYCLE AND
STARTING YOUR DRYER 4
OPERATING INSTRUCTIONS 6
The Automatic Cycles. 6
Timed Drying 6
DRYING TIPS. . 7
FLUFFAIR Setting . 7
TUMBLE PRESS@Setting 7
Gentle Heat
Drying Times . ;
Mixed Loads.. 8
01986 Whirlpool Corporation
kd-of-Cycle Signal
Lint Signal
LINT SCREEN
LINT REMOVAL
CARING FOR YOUR DRYER
Cleaning Dryer Interior.
Vacation Care. . . . . .
IF YOU NEED SERVICE OR
ASSISTANCE. .
1. Before Calling for
Assistance .
2. IfYou Need Assistance
3. IfYou Need Service .
4. If You Have a Problem
11
11
11
11
11

I
I
Your
Responsibilities
Read this “Use and Care Guide”
and your “Dryer Guide” carefully for
important use and safety information.
You are personally responsible for
making sure that your dryer...
l is installed by a qualified installer.
l is properly maintained.
l is installed in an area protected
from the weather.
l is properly installed and leveled in
a well ventilated room* on a floor
that can support the weight.
l is located in an area where the tem-
perature is above 45°F (7.2”C).
l is connected to the right kind of out-
let, electric supply and grounding.*
l is properly connected to fuel and
exhaust systems.*
l is used only for jobs normally ex-
pected of home clothes dryers.
l is not run where there may be explo-
sive fumes,
l is not used by children or anyone
unable to operate it properly.
*See the “Installation Instructions” for
complete information.
l FOR YOUR SAFETY l
, IF YOU SMELL GAS:
1. OPEN WINDOWS.
2. DON’T TOUCH ELECTRI-
CAL SWITCHES.
3. EXTINGUISH ANY OPEN
FLAME.
4. IMMEDIATELY CALL
YOUR GAS SUPPLIER.
l FOR YOUR SAFETY l
DO NOT STORE OR USE
GASOLINE OR OTHER

TYPE OF LOAD
COTTONS; LINENS
EXTRA HEAVY - Bedspreads,
mattress padsquilts.
HEAVYWEIGHT FABRICS -Towels,
jeanscorduroyswork clothes
MEDIUMWEIGHT COTTONS -
Sheets, pillowcases, cotton
underwear,diapers
LIGHTWEIGHT COTTONS - Batistes,
oraandies, lingerie
SUGGESTED SUGGESTED
CYCLE TEMPERATURE
HEAVY
HIGH
AUTOMATIC PERM7 PRESS
REGULAR MED
KNITS GENTLE
LOW
PERMANENT PRESS. SYNTHETICS
AND BLENDS ’
HEAVYWEIGHT FABRICS -Work clothes, PERM’T PRES!
jackets, raincoats AUTOMPr’fi - --- . . .
MEDIUMWEIGHT FABRICS - Shirts, play PERMAN
clothessheetsslacks . . . PRESS
LIGHTWEIGHT FABRICS - Lingerie, MED LOW
blouses, dresses .
KNITS
HEAVYWEIGHT - Cottons, rayons, MED LOW
blend&T-shirtsslacks, shirts . . . AUTOMATIC
LIGHTWEIGHT - Synthetics (polyester, PERMANENT
PRESS KNITS GENTLE
acrylic, etc.) and blends, lingerie, LOW
blouses, dresses . . .
LIGHTWEIGHT AND DELICATE FABRICS AUTOMATIC
Sheer Curtains (2 or 3 panels] . . . . PERMANENT
Gauze,lace,etc. . . . . . . . . . . . . . . . . . . . . . . . . PRESS Ex LOW
RUBBER, PLASTIC, HEAT-SENSITIVE PERMIT PRESS
FABRICS
FOAM RUBBER - Pillows, bras,
stuffed toys 20-30 MINS. FLUFF
PLASTIC - Shower curtains, AIR
tablecloths . . 20-30 MINS.
RUBBER-BACKED RUGS . . . 40-50 MINS.

the cycles.
Turn the Control Knob either way to The Temperature Selector can be set
point to the cycle and setting you on any desired temperature or any-
want. See page 6 for information On where between 2 temperatures.
To stop and restart
the dryer
Push the
3. START Button
Select a
1. CYCLE Set TEMPERATURE,
2. SELECTOR
The dryer will start tumbling when
you push the START Button. To stop the dryer, open the door (or turn the Control Knob to OFF].
To restart the dryer, close the door,
select cycle, if necessary, and push
START.
The Cycle Control Knob should point to OFF when the dryer is not in use.

I
I’
Operating instructions
The automatic cycles
The automatic cycles allow you
to select the degree of dryness you
prefer for the clothes being dried.
The Control Knob moves and stops
several times until the load reaches
the dryness setting you selected. Then
the knob automatically moves to
OFF and tumbling stops.
weight cotton items. The load tum-
bles without heat during the last 5
minutes. This helps make the load
easier to handle.
press, knits and other synthetic fab-
rics The load tumbles without heat
during the last 10 minutes. This helps
keep wrinkles from setting in.
For the first few loads, set the Control
Knob to point to an* in either auto-
matic cycle. When the dryer stops,
feel the dried items.
l If items are drier than you like, use
a setting to the right of the* the next
time you dry a similar load.
l If items are not as dry as you like,
use a setting to the left of the * the
next time you dry a similar load.
llmeddryins
Use the TIMED DRYING Cycle for
any load you want to dry by time. For
example: small loads, large bulky
items, items to be fluffed or dusted
with the FLUFFAIR heat setting.
l Turn the Control Knob to the number
of minutes you want - from 10 to 70.
l The last 10 minutes of this CyCle are
without heat - a cool-down time. This
helos make the load easier to
handle.
6

Drying tips
The dryer does not heat when the
Control Knob is set on FLUFFAIR. This
setting can be used to fluff bedding,
plastic tablecloths, foam rubber pil-
lows, stuffed toys, sneakers, etc.
1. Turn the Control Knob to the number
of minutes you want in FLUFFAIR.
2. Push the STARTButton.
TUMBLE PRESS” Setting
The TUMBLE PRESS setting removes
wrinkles from dry clothing such as
items that may have been packed
in a suitcase, closet, or items not
removed from the dryer.
1. Set Control Knob to TUMBLE PRESS.
2. Set Temperature Seledor to PERM’T
PRESS/ MED.
3. Push START Button.
The load will tumble in heated air
for 10 minutes. The heat shuts off and
the dryer continues to tumble the
load for 10 more minutes.
For best resultsTUMBLE PRESS only
a few items at a time. Put them on
hangers or fold them as soon as the
dryer stops.
Gentle Heat
The dryer automatically reduces the
heat setting in HEAVY HIGH and PERM’T
PRESSMED cycles. The last 7 minutes
of each of these cycles gradually
reduces the dryer temperature to a
lower heat setting. Thls helps prevent
over drying.

Drying times Mixed loads
Drying times will vary depending on:
0 amount of moisture in the clothes.
0 type and weight of the fabric.
l size of the load.
l room temperature around the
dryer.
l temperature of the wash rinse
water.
l amount of lint in the lint screen,
l dryer temperature selection.
See page 6 in your “Dryer Guide”
for more information.
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested forthe lightest fab-
rics. When the dryer stops, remove
dry items and reset the control.
End-of-cycle signal
The dryer sounds a signal to let you know
when the cycle is finished. The signal cannot be
turned off and is not adjustable.
The signal is helpful when you are drying
permanent press, synthetics and other items
that should be taken out as soon as the dryer
stops.
Lint signal
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The (whistle tone) signal lets you know
the air How is being restricted. Restricted air flow
reduces drying efficiency
Turn off the dryer and clean the lint screen as
shown on page 9.

Lint screen
Clean the lint screen before each load. A screen blocked by lint can
y be a FIRE HAZARD.
Lint removal
Lint can gather inside the dryer and create a fire hazard.This lint
should be removed every 2 to 3 years, or more often, depending on
dryer usage.
ELECTRIC DRYERS GAS DRYERS
Cleaning should be done only by a qualified person.
0
WARNING:
l Avold electrical shock
hazard - unplug power
supply cord or turn off
electrical power.
l Avoid injury or damage - do not
put hands inside cabinet.
l Make sure dryer is cool.
1. Remove back panel (electric)
or lower access panel (gas].
2. Avoid damaging wires,
thermostats, funnel or igniter.
3. Remove lint from shaded area -
see art- with a soft brush or
vacuum cleaner.
4. Replace panel: reconnect and
re-level dryer.
C

Caring for your dryer
Remove loose and sharp objects Some pretreatment products can
from Dockets and cuffs before drying - damaae dials. consoles and finish.
pins, buckles, etc. Close metal -
zippers.
Wipe off all spills with a damp, soft
cloth. Spills allowed to remain may
dull or damage the finish.
Never leave wet or damp laundry
in your dryer.
Sharp or heavy objects should
never be put on or in the dryer.
Check pockets for bolts, nuts, etc.
10
Do not’;se these products on or
near your dryer.
Cleaning dryer interior
WARNING: Before
cleaning interior, unplug
power supply cord, or
turn off electrical power to
avoid electrical shock hazard.
Garments which contain unstable dyes,
such as denim blue jeans or bright-
ly colored cotton items, may discolor
the dryer interior. If the interior
is discolored, clean with one of the
following methods to avoid staining
later load items.
Powdered laundry detergent and
very warm water
Make a paste with detergent and
very warm water. Apply paste to
a soft cloth and scrub area until all
excess dye is removed. Wipe thor-
oughly with a damp cloth. Tumble
a load of rags. -OR-
liquid spray household cleaner
Spray on stained area. Rub with a
cloth until all excess dye is re-
moved. Tumble a load of rags.
Vacation care
l Unplug power cord or turn off elec-
trical power.
l For gas dryers, close gas valve.
l Clean lint screen.